Calculation of influence of insulated bearings and insulated inner bearing seats on circulating bearing currents in machines of inverter-based drive systems
Authors:
- A. BinderABA. Binder
- 17 July 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 42 (4) , 965-972
Abstract
The high-frequency (HF) circulating bearing current that may occur in the machines of the inverter-based drive systems can be reduced or even completely suppressed by the use of the electrically insulated bearings or the insulated inner bearing seats. This paper proposes a method to calculate the influence of the thickness of the insulating coat on the obtained current reduction as a function of the several machine-design parameters. The parameters of the equivalent circuit are derived from an eddy-current model. The calculation considers the transient nature of the current flow. For the standard fan-cooled motors with up to 500-kW rated power, a minimum thickness of the insulating coat of 250 mum is required to reduce the circulating bearing currents to values where the apparent bearing-current density is less than 0.1 A/mm2, which is commonly taken as the threshold to the bearing failureKeywords
This publication has 10 references indexed in Scilit:
- Calculation of circulating bearing currents in machines of inverter-based drive systems2004
- Bearing Current Remediation Options: Sources, Investigative Measurements, and Installation Modifications to Reduce Damage as a Result of Bearing CurrentsIEEE Industry Applications Magazine, 2004
- Experimental evaluation of mitigation techniques for bearing currents in inverter-supplied drive-systems - investigations on induction motors up to 500 kW2003
- Bearing Fluting: The Results of a Long-Term Investigation into Bearing Fluting on AC Motors, DC Motors, and Rolls on Paper MachinesIEEE Industry Applications Magazine, 2002
- Wellenspannungen und zirkulierende Lagerströme bei umrichtergespeisten InduktionsmaschinenElectrical Engineering, 2000
- Minimizing Electric Bearing Currents in ASD SystemsIEEE Industry Applications Magazine, 1999
- System electrical parameters and their effects on bearing currentsIEEE Transactions on Industry Applications, 1997
- The effects of PWM voltage source inverters on the mechanical performance of rolling bearingsIEEE Transactions on Industry Applications, 1997
- Modeling and damping of high-frequency leakage currents in PWM inverter-fed AC motor drive systemsIEEE Transactions on Industry Applications, 1996
- Effect of operating parameters on the threshold voltages and impedance response of non-insulated rolling element bearings under the action of electrical currentsWear, 1987