Enhancement of the tribological performance and surface wettability of Ti6Al4V biomedical alloy with boric/sulfuric acid anodic film
Authors:
- M T AcarMAM T Acar
- H KovacıHKH Kovacı
- A ÇelikAÇA Çelik
- 24 August 2021
- journal article
- research article
- Published by IOP Publishing in Surface Topography: Metrology and Properties
- Vol. 9 (3) , 035024
Abstract
Titanium and its alloys have many advantages such as acceptable biocompatibility and good corrosion resistance and these advantages make them a widely preferred biomaterial. However, it is also known that they have some disadvantages such as poor wear resistance and insufficient surface wettability. Therefore, to overcome this disadvantages, boric/sulfuric anodic films with different anodization time was formed on the surface of Ti6Al4V. The morphological and structural properties of anodic films were evaluated by XRD, XPS, SEM, Raman spectra, micro-hardness tester, 3D profilometer, and surface tension-meter. Also, the tribological behavior of them was analyzed by a pin-on-disk tribo-tester. The average coefficient of friction (CoF) of the untreated Ti6Al4V alloy is 0.37, while the CoF of boron containing TiO 2 anodic films is in the range of 0.04–0.15. Also, the anodic films reduced the wear rate by about 30% compared to the untreated Ti6Al4V. In addition to all these, it was observed that the anodic films changed the surface morphology. It was determined that the produced anodic films were in porous structures and with the increase of the applied anodizing time, the possibility of contacting the liquid with the surface increased.Keywords
This publication has 47 references indexed in Scilit:
- Investigation of wear behavior of titanium oxide films, produced by anodic oxidation, on commercially pure titanium in vacuum conditionsSurface and Coatings Technology, 2010
- Electrochemical disinfection of biologically treated wastewater from small treatment systems by using boron-doped diamond (BDD) electrodes – Contribution for direct reuse of domestic wastewaterWater Research, 2009
- Effects of Boron Doping on Photocatalytic Activity and Microstructure of Titanium Dioxide NanoparticlesIndustrial & Engineering Chemistry Research, 2006
- Enhancing surface free energy and hydrophilicity through chemical modification of microstructured titanium implant surfacesJournal of Biomedical Materials Research Part A, 2005
- Improvement of wear resistance of Ti–6Al–4V alloy by means of thermal oxidationMaterials Letters, 2005
- Corrosion resistance and biocompatibility of Ti–Ta alloys for biomedical applicationsMaterials Science and Engineering: A, 2005
- Biocompatibility of β-stabilizing elements of titanium alloysBiomaterials, 2004
- Osseous healing characteristics of three different implant typesClinical Oral Implants Research, 2003
- Enhanced wear resistance of titanium surfaces by a new thermal oxidation treatmentWear, 2000
- Surface modification of titanium alloys for combined improvements in corrosion and wear resistanceSurface and Coatings Technology, 1998