Manufacturing of Non-Stick Molds from Pre-Painted Aluminum Sheets via Single Point Incremental Forming
Open Access
- 20 June 2018
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 8 (6) , 1002
Abstract
The process of single point incremental formation (SPIF) awakens interest in the industry of mold manufacturing for the food industry. By means of SPIF, it is possible to generate short series of molds or mold prototypes at low cost. However, these industries require such molds to be functional (non-sticky) and to have an adequate geometry accuracy. This study presents a technique that enables direct manufacturing of molds from pre-coated sheets with non-stick resins. It has also studied the influence of two technological variables in the process (feed-rate and pitch) for different geometrical parameters of the mold. Low values of these variables result in a lower overall error in the profile obtained. However, in order to obtain greater detail in particular parameters (angles, depth), it is necessary to use higher values of feed-rate and pitch.Keywords
This publication has 39 references indexed in Scilit:
- Processing Metal Sheets by SPIF and Analysis of Parts QualityMaterials and Manufacturing Processes, 2013
- A sustainability point of view on sheet metal forming operations: material wasting and energy consumption in incremental forming and stamping processesJournal of Cleaner Production, 2012
- Forming Parameters and Forming Defects in Incremental Forming of an Aluminum Sheet: Correlation, Empirical Modeling, and Optimization: Part AMaterials and Manufacturing Processes, 2011
- The mechanics of incremental sheet formingJournal of Materials Processing Technology, 2009
- Single point incremental forming of tailored blanks produced by friction stir weldingJournal of Materials Processing Technology, 2009
- Economical and Ecological Aspects of Single Point Incremental Forming Versus Deep Drawing TechnologyKey Engineering Materials, 2007
- Incremental Forming Process for the Accomplishment of Automotive DetailsKey Engineering Materials, 2007
- Influence of some relevant process parameters on the dimensional accuracy in incremental forming: a numerical and experimental investigationJournal of Materials Processing Technology, 2004
- Forming parameters for incremental forming of aluminium alloy sheet metalProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2002
- Metal-flow phenomena in computerized numerically controlled incremental stretch-expanding of aluminum sheets.Journal of Japan Institute of Light Metals, 1996