Numerical simulation on crystallization-induced warpage of injection-molded PP/EPDM part
- 23 August 2019
- journal article
- research article
- Published by Springer Nature in Journal of Polymer Research
- Vol. 26 (9) , 228
Abstract
No abstract availableKeywords
Funding Information
- China National Funds for Distinguished Young Scientists (51603122)
This publication has 36 references indexed in Scilit:
- Comparison of injection molding processability of polylactic acid and high density polyethylene via computational approachJournal of Polymer Engineering, 2013
- Shear-Induced Nucleation and Growth in Isotactic PolypropyleneMacromolecules, 2010
- A model for post-flow induced crystallization: General equations and predictionsJournal of Rheology, 2004
- A comparison of FENE and FENE-P dumbbell and chain models in turbulent flowJournal of Non-Newtonian Fluid Mechanics, 2003
- Structure Development during Shear Flow-Induced Crystallization of i-PP: In-Situ Small-Angle X-ray Scattering StudyMacromolecules, 2000
- Kinetic of crystallization from the melt and chain folding in polyethylene fractions revisited: theory and experimentPolymer, 1997
- Experimental and theoretical studies of shrinkage, warpage, and sink marks of crystalline polymer injection molded partsPolymer Engineering & Science, 1995
- The influence of rubber‐matrix interfaces on the crystallization kinetics of isotactic polypropylene blended with ethylene‐propylene‐diene terpolymer (EPDM)Polymer Engineering & Science, 1993
- Parameters characterizing the kinetics of the non-isothermal crystallization of poly(ethylene terephthalate) determined by d.s.c.Polymer, 1978
- Kinetic Parameters from Thermogravimetric DataNature, 1964