High Performance Platinum Group Metal-Free Cathode Catalysts for Microbial Fuel Cell (MFC)
Authors:
Open Access
- 6 December 2016
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 164 (3) , H3041-H3046
Abstract
The oxygen reduction reaction (ORR) at the cathode is usually the limiting step in microbial fuel cells and improvements have to be done to increase the performances and reduce the cost. For the first time, iron-based catalysts were synthesized utilizing the polymerization-pyrolysis method and tested successfully in neutral media and in working microbial fuel cells (MFCs). The catalysts were synthesized using polymerization, salt formation, mixed with iron salt and pyrolyzed at 850°C (PABA-850) and 950°C (PABA-950) respectively. To study the kinetics, electro-activity of the catalysts was investigated using rotating ring disk electrode (RRDE). Results showed that PABA-850 had higher catalytic activity compared to that of PABA-950. Both Fe-catalysts had much better activity compared to activated carbon (AC) used as a baseline. Catalysts were then integrated into air breathing cathodes (loading 1 mg cm−2) and tested in single chamber MFC. The power peak obtained was 178 ± 3 μWcm−2 for PABA-850. Comparable power was produced from PABA-950 (173 ± 3 μWcm−2). AC power output was 131 ± 4 μWcm−2 that was roughly 40% lower compared to Fe-based catalysts. Those results demonstrated that the addition of platinum group metal free (PGM-free) catalysts increased the output of the MFCs substantially. Fe-based catalysts seem to be suitable for large-scale MFC applications.Keywords
Funding Information
- Bill and Melinda Gates Foundation (OPP1139954)
This publication has 53 references indexed in Scilit:
- Use of Pyrolyzed Iron Ethylenediaminetetraacetic Acid Modified Activated Carbon as Air–Cathode Catalyst in Microbial Fuel CellsACS Applied Materials & Interfaces, 2013
- Influence of Chemical and Physical Properties of Activated Carbon Powders on Oxygen Reduction and Microbial Fuel Cell PerformanceEnvironmental Science & Technology, 2013
- Application of iron-based cathode catalysts in a microbial fuel cellElectrochimica Acta, 2011
- Manganese dioxide as a new cathode catalyst in microbial fuel cellsJournal of Power Sources, 2010
- Microbial Fuel Cells, A Current ReviewEnergies, 2010
- Power generation using an activated carbon and metal mesh cathode in a microbial fuel cellElectrochemistry Communications, 2009
- Cathodic limitations in microbial fuel cells: An overviewJournal of Power Sources, 2008
- Application of pyrolysed iron(II) phthalocyanine and CoTMPP based oxygen reduction catalysts as cathode materials in microbial fuel cellsElectrochemistry Communications, 2005
- On the mechanism of sulfur poisoning of platinum catalystsJournal of Catalysis, 1972
- Poisoning of platinum catalysts with a low content of active metal on a carrier, under conditions of dehydrogenation catalysisRussian Chemical Bulletin, 1952