Study on the Effect of Recycled Fine Aggregate Qualities on Fly Ash/GGBS-Based Geopolymer Mortar
Open Access
- 23 November 2023
- Vol. 16 (23) , 7289
Abstract
The rapid expansion of construction, fueled by industry and economic and population growth, has exacerbated the challenge of managing construction waste, especially concrete waste. One promising solution lies in the utilization of recycled fine aggregate (RFA), especially in combination with the emerging geopolymer technology, an innovative alternative to traditional cement. This study systematically explores the effects of incorporating varying qualities and quantities of RFA into geopolymer mortars. By using GGBS and FA as raw materials and replacing natural aggregates (NA) with RFA at different rates (25%, 50%, 75%, and 100%), the research investigates the fresh properties, mechanical characteristics, and drying shrinkage of geopolymer mortar. Key findings reveal that RFA significantly influences the flowability of geopolymer mortar: when RFA content is above 75%, preprocessed RFA (with particles below 0.15 mm removed) has substantially improved flowability, increasing it more than 20%. The critical impact of RFA preprocessing on enhancing mechanical properties and the higher the inclusion level (above 75%), the more pronounced is the advantage in enhancing the compressive strength compared to unprocessed RFA. Additionally, RFA was found to contribute to a denser interfacial transition zone (ITZ) than natural aggregate, which helps maintain the compressive strength at increased RFA dosages. Contrary to findings in cement mortar, a positive correlation exists between pore volume and compressive strength in geopolymer mortar incorporating RFA. This study underscores the potential of refined RFA preprocessing methods in advancing sustainable construction, highlighting avenues for the broader application of RFA in geopolymer mortar.Keywords
Funding Information
- Environmental Restoration and Conservation Agency (ERCA) (JPMEERF20213G03)
This publication has 53 references indexed in Scilit:
- The influence of the NaOH solution on the properties of the fly ash-based geopolymer mortar cured at different temperaturesComposites Part B: Engineering, 2014
- Carbon dioxide equivalent (CO2-e) emissions: A comparison between geopolymer and OPC cement concreteConstruction and Building Materials, 2013
- Incorporation of fine concrete aggregates in mortarsConstruction and Building Materials, 2012
- Experimental study on the failure mechanism of recycled concreteCement and Concrete Research, 2011
- The effects of Na2O/SiO2molar ratio, curing temperature and age on compressive strength, morphology and microstructure of alkali-activated fly ash-based geopolymersCement and Concrete Composites, 2011
- Effect of Recycled Sand Content on Characteristics of Mortars and ConcretesJournal of Materials in Civil Engineering, 2011
- Influence of paste/mortar rheology on the flow characteristics of high-volume fly ash self-consolidating concreteMagazine of Concrete Research, 2007
- Removal of cement mortar remains from recycled aggregate using pre-soaking approachesResources, Conservation and Recycling, 2007
- Treatments for the Improvement of Recycled AggregateJournal of Materials in Civil Engineering, 2004
- The ITZ in concrete – a different view based on image analysis and SEM observationsCement and Concrete Composites, 2001