Dry deposition of metal elements on surrogate surfaces in the ambient air of central Taiwan
Authors:
- 19 September 1997
- journal article
- research article
- Published by Taylor & Francis in Toxicological & Environmental Chemistry
- Vol. 62 (1-4) , 111-123
Abstract
Different surrogate surface were used to measure the atmospheric dry deposition flux of total‐particle mass and metals. Three different surrogate surface (overhead projection, T60A20 and Teflon) and two absorbent grease (Apenzion L grease and silicone grease) were compared and investigated. The results of this study indicated that using the Teflon filter coated with the silicone grease yielded the minimum background interference and high reproducibility for metal dry deposition analysis. Dry deposition and particle concentration were sampled simultaneously among three sampling sites (THU, JES and SES) with several dry deposition plates and TSP (total suspended particle) samplers from October 1994 to December 1995 at the central Taiwan. Six individual metals (Ca, Fe, Zn, Pb, Cu and Cd) were analyzed primarily with an AA‐680/G flame atomic absorption spectrophotometer. The results showed that the highest dry deposition flux, concentration of total particle‐mass and metals occurred in the SES sampling site which had the highest mean wind speed. In general, the crustal metals (Fe, Ca) had higher dry deposition velocities, while the anthropogenic metals (Zn, Pb, Cu, Cd) had lower dry deposition velocities for all three sampling sites. The mean dry deposition velocities of total particle‐mass. Fe and Ca were 9.32, 1.93 and 1.67 cm/sec, respectively. The mean dry deposition velocities of Zn, Pb, Cu and Cd were 0.51, 0.32, 0.11 and 0.26 cm/sec, separately. The results also indicated that the deposition velocities were overestimated for mass, Fe and Ca during high wind speed for these three sampling sites compared to previous studies. A suitable sampling device to collect coarse particles is needed to verified this result. In addition, re‐suspension phenomena are significant for these three sampling sites.Keywords
This publication has 13 references indexed in Scilit:
- Trace elements in atmospheric precipitation at Norweigan background stations (1989–1990) measured by ICP-MSAtmospheric Environment, 1994
- Dry deposition and particle size distributions measured during the Lake Michigan Urban Air Toxics StudyEnvironmental Science & Technology, 1993
- A comparison of dry deposition modeled from size distribution data and measured with a smooth surface for total particle mass, lead and calcium in ChicagoAtmospheric Environment. Part A. General Topics, 1993
- Dry Deposition of Atmospheric Contaminants: The Relative Importance of Aerodynamic, Boundary Layer, and Surface ResistancesAerosol Science and Technology, 1992
- Dry deposition of polychlorinated biphenyls in urban areasEnvironmental Science & Technology, 1991
- Characterization of the deposition of particles from the atmosphere to a flat plateAtmospheric Environment (1967), 1988
- Wind Tunnel Modeling of Small Particle DepositionAerosol Science and Technology, 1986
- Characterization of large particles at a rural site in the eastern United States: Mass distribution and individual particle analysisAtmospheric Environment (1967), 1985
- Particle and gas dry deposition: A reviewAtmospheric Environment (1967), 1980
- Empirical atmospheric deposition parameters—A surveyAtmospheric Environment (1967), 1979