Influence of Workpiece Surface Topography on the Mechanisms of Liquid Lubrication in Strip Drawing
Authors:
- 23 May 2000
- journal article
- Published by ASME International in Journal of Tribology
- Vol. 123 (2) , 290-294
Abstract
The workpiece surface topography is an important factor controlling the mechanisms of lubrication in metal forming processes. In the present work, the microscopic lubrication mechanisms induced by lubricant trapped in pockets of the surface in strip drawing are studied. The experiments are performed with macroscopic model pockets in the surface studying the influence of the shape of the pockets on the lubrication mechanisms. A large radius of curvature on the rear edge and a small angle to the edge of the lubricant pocket induce a large area of backward escape of lubrication caused by microplasto hydrodynamic lubrication (MPHDL). On the other hand, when the radius on the edge is small MPHDL is impeded and microplasto hydrostatic lubrication appears instead implying forward escape of the lubricant. The occurrence of these mechanisms are quantitatively explained by a mathematical model combining a slab method of analysis of the strip drawing process and an analysis of lubricant escape by Reynolds equation.Keywords
This publication has 7 references indexed in Scilit:
- Entrapment and escape of liquid lubricant in metal formingWear, 1999
- A Theoretical Model of Micro-Pool Lubrication in Metal FormingJournal of Tribology, 1999
- A Basic Study of the Influence of Surface Topography on Mechanisms of Liquid Lubrication in Metal FormingCIRP Annals, 1999
- Topography Deformation of Sheet Metal during the Forming Process and Its Influence on FrictionCIRP Annals, 1997
- Development of deterministic-stochastic surface structures to improve the tribological conditions of sheet forming processesJournal of Materials Processing Technology, 1996
- Investigation of Factors Affecting the Coefficient of Friction and Surface Properties with a Sheet Drawing TestCIRP Annals, 1992
- Effects of Lubricant Viscosity at Pressure and Sliding Velocity on Lubricating Conditions in the Compression-Friction Test on Sheet MetalsJournal of Lubrication Technology, 1982