Molding of Thin Sheets Using Impact Micro-injection Molding
Authors:
- 1 August 2005
- journal article
- research article
- Published by Walter de Gruyter GmbH in International Polymer Processing
- Vol. 20 (4) , 441-448
Abstract
The micro-injection molding is used to fabricate ultra-thin polymeric components used in optoelectronics and biotechnology. Due to the extremely high flow resistance and fast heat transfer, ultra-thin parts is difficult to mold. In this study, a lab-made impact type micro-injection machine and a rapid heating/cooling system are used to perform the micro-injection molding. A mold with test-sheet cavities of thickness 100 lm and 200 lm are constructed. The molding capacity and the effects of processing conditions are systematically investigated. The processing conditions include the mold temperature, air pressure of accelerating cylinder, and air pressure of packing cylinder. The thicker parts have larger operation window. The high mold temperature reduces the area of short shot but induces more shrinkage and sink mark. The increase of air pressure in accelerating and packing cylinders can effectively reduce shrinkage.Keywords
This publication has 9 references indexed in Scilit:
- Review on micro molding of thermoplastic polymersJournal of Micromechanics and Microengineering, 2003
- Visualization analysis of flow front behavior during filling process of injection mold cavity by two-axis tracking systemJournal of Materials Processing Technology, 2002
- Process along thickness directionIEEE Transactions on Advanced Packaging, 2000
- Injection molding of polymeric LIGA HARMsMicrosystem Technologies, 1999
- Flow visualization of the gas‐assisted injection molding processAdvances in Polymer Technology, 1997
- Treating erosive oesophagitis cost effectivelyPharmacoResources, 1995
- Jetting phenomena in injection mold filling mold fillingPolymer Engineering & Science, 1976
- Fluid mechanical analysis of injection mold fillingPolymer Engineering & Science, 1975
- Flow visualization for injection molding of polyethylene and polystyrene meltsPolymer Engineering & Science, 1974