Finite element analysis of large-sized O-rings used in deep-ocean pressure chambers
Authors:
Open Access
- 20 August 2021
- journal article
- research article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 13 (8)
Abstract
A proper criterion to guide how to determine the cross-section diameter of non-standard large-sized O-rings used in deep-ocean pressure chambers (DOPCs) is absent. To design a large-sized O-ring only by scale-up could be a lack of persuasiveness, and it will probably cause the increase of cost. This paper gives a detailed study on the static sealing performance of O-rings by finite element analysis (FEA). The results show that the influence of the inside diameter of O-rings can be ignored, and the O-rings with a large cross-section diameter may not be applicable to the high-pressure DOPCs, but it can allow a larger sealing clearance to be used in the low-pressure DOPCs. The reference values of safe sealing pressure with different cross-section diameters and different sealing clearances are ascertained. An improved criterion to guide how to determine the cross-section diameter of non-standard large-sized O-rings used in DOPCs is proposed. The results obtained in this paper can provide a more convincing guideline for the O-ring sealing design not only in DOPCs but also in the similar pressure vessels.Keywords
Funding Information
- the “Construction of a Leading Innovation Team” project by the Hangzhou municipal government (041030150118)
- Westlake University (041030150118)
This publication has 10 references indexed in Scilit:
- Review of Deep-Ocean High-Pressure Simulation SystemsMarine Technology Society Journal, 2020
- Three-dimensional finite element analysis of O-ring metal seals considering varying material properties and different seal diametersInternational Journal of Pressure Vessels and Piping, 2019
- A deep-sea large-volume high-pressure simulation system—design, analysis and experimental verificationOcean Engineering, 2019
- Experimental and numerical studies on the buckling of the hemispherical shells made of maraging steel subjected to extremely high external pressureInternational Journal of Pressure Vessels and Piping, 2019
- Investigation of Static and Dynamic Seal Performances of a Rubber O-RingJournal of Tribology, 2018
- Finite element analysis and experimental study on contact pressure of hydraulic support bud-shaped composite sealing ringAdvances in Mechanical Engineering, 2016
- Finite Element Analysis2012
- Pressure Testing: Best PracticesMarine Technology Society Journal, 2009
- Fatigue, Stress, and Strain of Rubber Components2008
- Prediction of Extrusion Failures of O-Ring SealsA S L E Transactions, 1984