Identification and compensation of gear backlash without output position sensor in high-precision servo systems
Authors:
- J. HoltzJHJ. Holtz
- 27 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 2, 662-666
Abstract
High-performance position control can be improved by the compensation of gear backlash. This paper presents a compensation method that does not need an output position sensor. In the first section, two different methods of on-system backlash identification are described. One method is based on dynamic reaction to a small torque impulse injected by the motor, while the other analyses the change of torque at the end of the backlash dead zone in a quasi-stationary trajectory. The second section of the paper deals with backlash compensation. Based on the identified value of backlash, the angular error of the output shaft is reduced. A self-learning time-optimal control method is described. Experimental measurements demonstrate the excellent performance and accuracy of the compensated system.Keywords
This publication has 5 references indexed in Scilit:
- Identification and compensation of torque ripple in high-precision permanent magnet motor drivesIEEE Transactions on Industrial Electronics, 1996
- Neural network compensation of gear backlash hysteresis in position-controlled mechanismsIEEE Transactions on Industry Applications, 1995
- Adaptive friction compensation in dc-motor drivesIEEE Journal on Robotics and Automation, 1987
- Computer Simulation of Stick-Slip Friction in Mechanical Dynamic SystemsJournal of Dynamic Systems, Measurement, and Control, 1985
- Adaptive bearing friction compensation based on recent knowledge of dynamic frictionAutomatica, 1984