Dynamic Measurements of Beam-Pump Parameters
Authors:
- 1 February 1992
- journal article
- Published by Society of Petroleum Engineers (SPE) in SPE Production Engineering
- Vol. 7 (01) , 113-120
Abstract
Summary: Measurements of nine electrical and mechanical parameters were made on conventional and special-geometry units during operation. All quantities were measured simultaneously and computer-recorded for a variety of pumping conditions. Using this data, we compared measured dynamic gearbox torques with calculated values, illustrating how calculation techniques model dynamically measured data. Calculated efficiencies indicating losses through the units from polished rod to the gearbox are shown to be necessary for adjusting gearbox torque calculations to measured values. Also, torque/speed curves are shown at the motor sheave. These data are corrected for inertial effects and plotted vs. motor manufacturers’ published curves. Possibilities for future work incorporating these measurement techniques while the unit is in operation were discussed. In general, the data show how dynamically measured beam-pump data compare with conventional calculation techniques.Keywords
This publication has 5 references indexed in Scilit:
- Exact Kinematic Analysis of Pumping Units1983
- Computing Gearbox Torque and Motor Loading For Beam Pumping Units With Consideration of Inertia EffectsJournal of Petroleum Technology, 1975
- Predicting Prime Mover Requirements, Power Costs, And Electrical Demand For Beam Pumping Units1974
- Computer Diagnosis of Down-Hole Conditions In Sucker Rod Pumping WellsJournal of Petroleum Technology, 1966
- Predicting the Behavior of Sucker-Rod Pumping SystemsJournal of Petroleum Technology, 1963