Interface pressures and shear stresses
Authors:
- J. E. SandersJSJ. E. Sanders
- C. H. DalyCDC. H. Daly
Open Access
- 1 April 1999
- journal article
- research article
- Published by Wolters Kluwer Health in Prosthetics and Orthotics International
- Vol. 23 (1) , 21-29
Abstract
Interface pressures and shear stresses at different sagittal plane angular alignment settings were measured on 3 trans-tibial amputee subjects ambulating with patellar-tendon-bearing total contact prostheses. Substantial socket-shank angular alignment modifications in the sagittal plane had minimal effect on stance phase peak interface pressures, though more substantial effects on stance phase peak resultant shear stresses. No consistent trend of a greater stress at misaligned vs nominally aligned settings was identified. Changes in interface stresses from session to session tended to be greater than those for different alignment settings, suggesting that subjects compensated well for misalignments but less well for session differences.Keywords
This publication has 7 references indexed in Scilit:
- A Measurement Device to Assist Amputee Prothetic FittingJournal of Clinical Engineering, 1994
- Measurement of stresses in three orthogonal directions at the residual limb-prosthetic socket interfaceIEEE Transactions on Rehabilitation Engineering, 1993
- An angular alignment measurement device for prosthetic fittingProsthetics and Orthotics International, 1990
- Least-Squares Matrix Correlations Between Stump Stresses and Prosthesis Loads for Below-Knee AmputeesJournal of Biomechanical Engineering, 1987
- The Accuracy of Electrical Transducers for the Measurement of Pressure Applied to the SkinIEEE Transactions on Biomedical Engineering, 1979
- Stump-socket pressure in lower extremity prosthesesJournal of Biomechanics, 1968
- THE SKIN SURFACE AND FRICTION.British Journal of Dermatology, 1955