Performance Analysis of Helical Savonius River Current Turbine Using Computational Fluid Dynamic
Authors:
- 1 September 2019
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 595-600
Abstract
The potential of water power is spread throughout Indonesia. The velocity of river flows in Indonesia is relatively low with an average of 0.6 m/s. With a low water velocity, a vertical axis turbine is used for better efficiency values and maximized blade’s lift by using twisting. In this study using vertical axis helical turbines with overlapping variations. Helical savonius turbine with a 45 o twist and 3 blades are designed to improve turbine performance. This study compares the horizontal axis helical savonius river current with variations in the overlap ratio of 0.1, 0.2, 0.3, and 0.4. Validation of turbine design was done by simulation using fluent software to determine numerical analysis and best performance. The simulation was performed on ANSYS 19.2 with standard k-epsilon modeling and SIMPLEC algorithm. From the simulation results obtained overlap ratio 0.1 had the most maximal turbine performance compared to other overlap variations due to the greatest pressure and velocity difference and the greatest coefficient of torque value.Keywords
This publication has 4 references indexed in Scilit:
- Experimental and computational evaluation of Savonius hydrokinetic turbine for low velocity condition with comparison to Savonius wind turbine at the same input powerEnergy Conversion and Management, 2014
- PERFORMANCE ANALYSIS OF A HELICAL SAVONIUS ROTOR WITHOUT SHAFT AT 45° TWIST ANGLE USING CFDJournal of Urban and Environmental Engineering, 2013
- Discussion on the verification of the overlap ratio influence on performance coefficients of a Savonius wind rotor using computational fluid dynamicsRenewable Energy, 2012
- Experimental investigations on single stage, two stage and three stage conventional Savonius rotorInternational Journal of Energy Research, 2008