Influence of the curing method on the post-polymerization shrinkage stress of a composite resin
Open Access
- 1 August 2008
- journal article
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 16 (4) , 266-270
Abstract
The aim of this study was to evaluate the effect of different curing methods on the stress generated by the polymerization shrinkage of a restorative composite in two moments: immediately after light exposure and after 5 min. Photoactivation was performed using two different light sources: (1) xenon plasma arc (PAC) light (1,500 mW/cm2 – 3s) and (2) a quartz-tungsten-halogen (QTH) light with three light-curing regimens: continuous exposure (40 s at 800 mW/cm2 – CL); soft-start (10 s at 150 mW/cm2 and 30 s at 800 mW/cm2 - SS) and intermittent light [cycles of 4 s (2 s with light on at 600 mW/cm2 and 2 s of light off), for 80s – IL]. The composite resin was applied between two 5-mm diameter metallic rods, mounted in a servohydraulic machine. The maximum stress was recorded immediately after light exposure (FF) and after 5 min (5F). The results were submitted to ANOVA and Tukey's test (5%). For each method, the results obtained in FF and 5F were, respectively: CL (3.58 and 4.46 MPa); SS (2.99 and 4.36 MPa); IL (3.11 and 4.32 MPa) and PAC (0.72 and 3.27 MPa). The stress generated by the polymerization shrinkage during light exposure can be associated with the photoactivation method used. A significant increase in the stress level was observed during the post-curing period up to 5 min, for all evaluated methods.Keywords
This publication has 27 references indexed in Scilit:
- The Knoop Hardness of a Composite Resin Polymerized with Different Curing Lights and Different ModesThe Journal of Contemporary Dental Practice, 2007
- Modulated photoactivation methods—Effect on marginal and internal gap formation of restorations using different restorative compositesJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2007
- Contraction force rate of polymer composites is linearly correlated with irradianceDental Materials, 2004
- Comparison of post-gel shrinkage strains in light-polymerized composite resinsThe Journal of Prosthetic Dentistry, 2002
- Effect of the photo-activation method on polymerization shrinkage of restorative composites.2002
- Polymerization contraction stress in light-cured packable composite resinsDental Materials, 2001
- Comparison between a plasma arc light source and conventional halogen curing units regarding flexural strength, modulus, and hardness of photoactivated resin compositesClinical Oral Investigations, 2000
- Post-irradiation polymerization of composites containing bis-GMA and TEGDMADental Materials, 1999
- Stress transfer from polymerization shrinkage of a chemical-cured composite bonded to a pre-cast composite substrateDental Materials, 1998
- Effect of light intensity and exposure duration on cure of resin composite.1994