Processing properties of polypropylene with a minor addition of silicone oil
Authors:
- 24 June 2010
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 50 (7) , 1340-1349
Abstract
Processing‐related properties of a polypropylene (PP)/silicone oil blend were investigated. It was found that an addition of a small amount (∼2 wt%) of silicone oil, a low molecular weight linear poly(dimethyl siloxane) (PDMS), drastically changed the rheological properties of PP. The PDMS seemed to work both as an internal lubricant and an external lubricant in the blend system. In particular, the apparent viscosity of the blend in capillary rheometry was approximately 10 times lower than that of virgin PP. The local minima in the viscosity versus shear rate curve in capillary rheometry and the gap‐dependency of viscosity in parallel‐plate rheometry implied the existence of a slip wall condition, caused by the formation of a thin lubricant layer at die walls. Thermal analyses and mechanical tests showed that the thermal and mechanical properties of the blend were nearly unaffected by the minor addition of silicone oil. The blend was tested in a profile extrusion process, and a significant reduction in die swell and profile distortion was achieved. The jet stretchability or spinnability in fiber spinning was also greatly improved with the minor addition of silicone oil. POLYM. ENG. SCI., 2010. © 2010 Society of Plastics EngineersKeywords
Funding Information
- National Science Foundation (CMMI-0826259)
This publication has 18 references indexed in Scilit:
- Investigation of PPA interactions with polymer melts in single layer extrusion and coextrusion flowsPlastics, Rubber and Composites: Macromolecular Engineering, 2007
- Nanomechanical and surface frictional characteristics of a copolymer based on benzoyl-1,4-phenylene and 1,3-phenylenePolymer, 2006
- Shear field induced diffusion and molecular weight fractionation during polymer processingPolymer Engineering & Science, 2004
- Flow induced coating of fluoropolymer additives: Development of frustrated total internal reflection imagingJournal of Rheology, 2003
- Development of rapid heating and cooling systems for injection molding applicationsPolymer Engineering & Science, 2002
- Functionalizing polymer surfaces by field‐induced migration of copolymer additives—role of shear fieldsPolymer Engineering & Science, 2002
- INCREASING FLOW LENGTH IN THIN WALL INJECTION MOLDING USING A RAPIDLY HEATED MOLDPolymer-Plastics Technology and Engineering, 2002
- Characterization of the lubricant layer formed at the interface between the extrudate and the die wall during the extrusion of high density polyethylene and fluoroelastomer blends by XPS, SIMS and SEMPolymer Engineering & Science, 1999
- Effects of Interfacial Conditions on Wall Slip and Sharkskin Melt Fracture of HDPEInternational Polymer Processing, 1993
- Effect of Surface Coatings on Wall Slip of LLDPEInternational Polymer Processing, 1993