A novel multilayer composite structured thermoelectric module with high output power
- 17 January 2020
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 8 (6) , 3379-3389
Abstract
Output power is a vital criterion for evaluating the heat–electricity conversion capability of thermoelectric power generators (TEGs). This study for the first time proposes a novel (Bi,Sb)2Te3-based multilayer composite structured thermoelectric module (MCTEM) that can achieve high power output. Parallel heat transfer and electrical parallel connection are simultaneously achieved in an n-type single-leg MCTEM which is composed of several alternately stacked thermoelectric slices and inner electrodes. The extremely low inner resistance (Rin) and high current (I) are 0.03 and 12.7 times those measured in a single-leg traditional module, respectively, and then a maximum output power (Pmax) of 5.8 mW is achieved at ΔT = 35 °C. The effect of the slice number on module performance has been investigated, and the optimal Pmax for n- and p-type single-leg MCTEMs has been achieved when using 3 slices. Based on the optimized single-leg MCTEMs mentioned above, a π-type MCTEM has been designed to improve the output voltage (V) and further enhance the Pmax. The π-type MCTEM achieves a high V of 3.1 mV while maintaining a low Rin of 0.94 mΩ and a large I value of 3.3 A, and then a Pmax of 10.5 W is obtained which is 4.2 times that of the traditional module at ΔT = 35 °C. This new design of a MCTEM provides enlightenment for fabrication and commercialization through the development of high-power TEGs.Keywords
Funding Information
- National Key Research and Development Program of China (2017YFE0195200, 2013CB632506)
- National Natural Science Foundation of China (51871134, 51672159)
- Shandong University (2015WLJH21)
- State Key Laboratory of Metastable Materials Science and Technology (201703)
- Gobierno de Aragón (T54-17R)
- Ministerio de Economía y Competitividad (MAT2017-82183-C3-1-R)
This publication has 33 references indexed in Scilit:
- Silver as a highly effective bonding layer for lead telluride thermoelectric modules assembled by rapid hot-pressingEnergy Conversion and Management, 2015
- Reducing energy demand: A review of issues, challenges and approachesRenewable and Sustainable Energy Reviews, 2015
- Current progress and future challenges in thermoelectric power generation: From materials to devicesActa Materialia, 2015
- Thermoelectrical properties of lutetium-doped Bi2Te3 bulk samples prepared from flower-like nanopowdersJournal of Alloys and Compounds, 2015
- Right sizes of nano- and microstructures for high-performance and rigid bulk thermoelectricsProceedings of the National Academy of Sciences, 2014
- Finite Element Analysis and Design of Thermal–Mechanical Stresses in Multilayer Ceramic CapacitorsInternational Journal of Applied Ceramic Technology, 2013
- Fabrication of Highly (0 0 l)-Textured Sb2Te3 Film and Corresponding Thermoelectric Device with Enhanced PerformanceJournal of Electronic Materials, 2012
- p-type Bi0.4Sb1.6Te3 nanocomposites with enhanced figure of meritApplied Physics Letters, 2010
- Evaluation of thermoelectric modules for power generationJournal of Power Sources, 1998
- Multilayer ceramic capacitorsCurrent Opinion in Solid State and Materials Science, 1997