Correlation analysis of microstructure evolution on microhardness and residual stress for cutting Ti-6Al-4V titanium alloy
Authors:
- 9 September 2022
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 237 (6-7) , 885-898
Abstract
Microstructural variation of material directly affects the macroscopic and microscopic mechanical properties of the machined surface. This research investigates the correlation between microstructure evolution and the variation of microhardness and residual stress for cutting Ti-6Al-4V titanium alloy. Firstly, a 2D customized finite element (FE) model has been performed to predict dynamic recrystallization (DRX) and resultant grain size by implementing modified Johnson-Cook(J-C) constitutive model and Johnson-Mehl-Avrami-Kolmogorov(JMAK) model. Then, orthogonal cutting experiments are conducted to verify the accuracy of the established FE model. The predicted values agree well with the measured values and the average error is 8.94% for average grain size. Finally, microhardness and residual stress along with radial direction are measured. The results of simulation and experiment indicate that both microhardness and residual stress profile present an opposite correlation with average grain size profile under different cutting conditions. The correlation analysis between microstructural variation and macroscopic mechanical properties on the surface further deepens the understanding of the machined surface integrity system.Keywords
This publication has 31 references indexed in Scilit:
- The effects of cooling conditions on surface integrity in machining of Ti6Al4V alloyThe International Journal of Advanced Manufacturing Technology, 2013
- Functional form of the Kolmogorov–Johnson–Mehl–Avrami kinetics for non-isothermal phase transformations at constant heating rateThermochimica Acta, 2013
- Finite Element-based Modeling of Machining-induced Residual Stresses in Ti-6Al-4V under Finish Turning ConditionsProcedia CIRP, 2013
- A MODIFIED MATERIAL MODEL FOR THE FINITE ELEMENT SIMULATION OF MACHINING TITANIUM ALLOYTi-6Al-4 VMachining Science and Technology, 2010
- Modified material constitutive models for serrated chip formation simulations and experimental validation in machining of titanium alloy Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2010
- NUMERICAL SIMULATION OF TITANIUM ALLOY DRY MACHINING WITH A STRAIN SOFTENING CONSTITUTIVE LAWMachining Science and Technology, 2010
- A new material model for 2D numerical simulation of serrated chip formation when machining titanium alloy Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2008
- The effect of machining on surface integrity of titanium alloy Ti–6% Al–4% VJournal of Materials Processing Technology, 2005
- Microstructural evolution of a Ti–6Al–4V alloy during thermomechanical processingMaterials Science and Engineering: A, 2002
- Simulation of surface roughness and profile in high-speed end millingJournal of Materials Processing Technology, 2001