Beam‐Column Behavior of Fabricated Steel Tubular Members
Authors:
- 1 May 1992
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 118 (5) , 1213-1232
Abstract
The results of a large‐scale experimental study on fabricated tubular steel members are presented. Twenty‐two specimens with a diameter of 450 mm and lengths varying between 1.5 and 10 m are fabricated and tested under various combinations of axial load and bending moment. Wall thicknesses vary between 4.5 and 8.8 mm, and the measured yield stress varies between 250 and 450 MPa, resulting in specimens with a cross‐sectional slenderness factor of α=Et/FyD of approximately 7.5 and 9.0; respectively. Laboratory measurements of weld‐induced residual strains and surface geometry of specimens before testing are examined in conjunction with observed behavior and are related to failure modes. The load‐deflection behavior up to and beyond ultimate load is studied, and test results are compared with existing and proposed design rules with respect to local buckling, strength, and stability interaction. Good agreement with stability modeling is seen, and observed differences with strength interaction equations are di...Keywords
This publication has 4 references indexed in Scilit:
- Local Buckling and Sectional Behavior of Fabricated TubesJournal of Structural Engineering, 1987
- Tests On Two High-Strength Shori Tubular Columns1978
- Tests of Fabricated Tubular ColumnsJournal of the Structural Division, 1977
- Tests of Circular Steel Tubes in BendingJournal of the Structural Division, 1976