Euro VI-d Compliant Diesel Engine’s Sub-23 nm Particle Emission
Open Access
Abstract
Passenger and commercial transportation significantly contribute to hazardous air pollution. Exhaust gas after-treatment technology advances closely to the emission regulations throughout the world. The upcoming legislation will be EURO VII in European Union, which requirements are not set yet, but the Solid Particle Number (SPN) diameter range is expected to be more severe compared to EURO VI. This paper will revisit the measurement principle differences between over 10 nm and over 23 nm diameter particles in theory and practical engine bench measurement. Two different types of particle counters have performed the soot particle counting measurement; therefore, the applied sensors are different in terms of applied counting principles. The measurement principles of both devices will be introduced, and the experiment’s result will reflect on the sensor differences. From this, a conclusion can be derived in order to determine the severity of the upcoming EURO VII legislation in terms of SPN, and the experiment will also reflect on the measurement sensor differences. The overall results suggested that extending the lower range of the measurement increases the tailpipe particle emission by 20%, although the DPF filtration efficiency is still over 99%.Keywords
This publication has 12 references indexed in Scilit:
- Experimental SCR system for engine dynamometer applicationsHungarian Agricultural Engineering, 2020
- Exhaust emission testing methods – BOSMAL’s legislative and development emission testing laboratoriesCombustion Engines, 2019
- Investigation of vehicle exhaust sub-23 nm particle emissionsAerosol Science and Technology, 2017
- Well to Wheel Cum Tailpipe Emission Analysis: ICE vs xEVSAE International Journal of Advances and Current Practices in Mobility, 2017
- Engine Exhaust Solid Sub-23 nm Particles: II. Feasibility Study for Particle Number Measurement SystemsSAE International Journal of Fuels and Lubricants, 2014
- Evaluation of an oxidation catalyst (“catalytic stripper”) in eliminating volatile material from combustion aerosolJournal of Aerosol Science, 2013
- Validating the single charged aerosol reference (SCAR) as a traceable particle number concentration standard for 10 nm to 500 nm aerosol particlesMetrologia, 2011
- Calibration and accuracy of a particle number measurement systemMeasurement Science and Technology, 2010
- Calibration of Condensation Particle Counters for Legislated Vehicle Number Emission MeasurementsAerosol Science and Technology, 2009
- Translocation of Inhaled Ultrafine Particles to the BrainInhalation Toxicology, 2004