FATIGUE CHARACTERISTICS OF SKD-61 BY ULTRASONIC NANOCRYSTAL SURFACE MODIFICATION TECHNOLOGY UNDER STATIC LOAD VARIATION
Authors:
- 30 June 2010
- journal article
- research article
- Published by World Scientific Pub Co Pte Ltd in International Journal of Modern Physics B
- Vol. 24 (15n16) , 2645-2650
Abstract
At first, the specimens of SKD-61 are prepared and tested to verify the effects of ultrasonic nano-crystal surface modification (UNSM) technology on the variation of mechanical properties under static load variation. 20 kHz frequency was applied to the ball tip, and the applied static forces were changed three kinds of load level 40, 60, and 80 N, respectively. The grain size of SKD-61 surface treated by UNSM becomes very fine to nano-scale crystal and structure is observed till certain depth. The compressive residual stress becomes -810, -1200 and -1400 MPa to a 150 µm depth after the UNSM process according to three kinds of load level 40, 60, and 80 N, respectively. Fatigue limits of 107 cycles are increased by 8.3, 11.2, and 17.9% after UNSM at the smooth specimen according to three kinds of load level, respectively. Interior-originating fracture, fish-eye crack, occurs after UNSM because of a nano structured modification by a surface plastic deformation and compressive residual stress in the case of the smooth specimen. UNSM improves the mechanical properties effectively and is becoming a practical method to improve the service life of the trimming knives. Productivity and reliability of a cold rolling process have improved more than 2 times by the application of the UNSM trimming knives.Keywords
This publication has 4 references indexed in Scilit:
- A STUDY OF THE MECHANICAL CHARACTERISTICS OF ULTRASONIC COLD FORGED SKD61International Journal of Modern Physics B, 2006
- Nano structure and transformation mechanism of white layer for AISI1045 steel during impact wearWear, 2005
- The developing of nanostructured spd ti for structural useScripta Materialia, 2001
- Equal channel angular extrusion: from macromechanics to structure formationMaterials Science and Engineering: A, 1999