High temperature zone‐drawing of nylon 66 microfiber prepared by CO2 laser‐thinning
Authors:
- 23 March 2006
- journal article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 101 (1) , 42-47
Abstract
A high temperature zone‐drawing method was applied to a nylon 66 microfiber, obtained by using CO2 laser‐thinning, to develop its mechanical properties. The microfiber used for the high temperature zone‐drawing was prepared by winding at 150 m min−1 the microfiber obtained by irradiating the laser at 4.0 W cm−2 to an original fiber with a diameter of 50 μm, and had a diameter of 9.6 μm and a birefringence of 0.019. The high temperature zone‐drawing was carried out in two steps; the first drawing was carried out at a temperature of 230°C at supplying and winding speeds of 0.266 and 0.797 m min−1, the second at 250°C at supplying and winding speeds of 0.266 and 0.425 m min−1, respectively. The diameter of the microfiber decreased, and its birefringence increased stepwise with the processing. The high temperature zone‐drawn microfiber finally obtained had a diameter of 4.2 μm, a birefringence of 0.079, total draw ratio of 4.8, tensile modulus of 12 GPa, and tensile strength of 1.0 GPa. The wide‐angle X‐ray diffraction photograph of the drawn microfiber showed the existence of highly oriented crystallites. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 101: 42–47, 2006Keywords
This publication has 14 references indexed in Scilit:
- Superstructure and mechanical properties of nylon 66 microfiber prepared by carbon dioxide laser-thinning methodJournal of Applied Polymer Science, 2005
- Isotactic polypropylene microfiber prepared by continuous laser‐thinning methodJournal of Applied Polymer Science, 2005
- Zone drawing and zone annealing of poly(ethylene terephthalate) microfiber prepared by CO2 laser thinningJournal of Applied Polymer Science, 2004
- Nylon 6 microfiber obtained by a continuous‐thinning method with a carbon dioxide laserJournal of Applied Polymer Science, 2004
- PBT/PET conjugated fibers: Melt spinning, fiber properties, and thermal bondingPolymer Engineering & Science, 2004
- Thermal properties relevant to the processing of PET fibersJournal of Applied Polymer Science, 2003
- Attenuating PP/PET bicomponent melt blown microfibersPolymer Engineering & Science, 2003
- Extruded continuous filament nonwovens: Advances in scientific aspectsJournal of Applied Polymer Science, 2001
- Application of a continuous zone-drawing method to nylon 66 fibresPolymer, 1998
- Structural analysis of injection-moulded semicrystalline polymers by Fourier-transform infra-red spectroscopy with photoacoustic detection and differential scanning calorimetry: 2. Polyamide-6,6Polymer, 1994