Dynamics and criteria for bubble instabilities in a single layer film blowing extrusion
- 1 February 2004
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 44 (2) , 283-302
Abstract
In this paper, the performance of a new in‐line scanning camera system for the study of various bubble instabilities in film blowing extrusion is critically evaluated. Three commercial film‐grade polyethylenes, LmPE, LLDPE and LDPE, were used to generate the bubble instabilities. Reliable and objective criteria for differentiating various bubble instabilities such as draw resonance, helicoidal instability, and frost line height instability are proposed by using the new device. Detailed dynamics of each bubble instability was carefully investigated as a function of time in a broad range of the take‐up ratio (TUR), blow‐up ratio (BUR) and frost line height (FLH). In addition, effects of melt temperature and mass flow rates on dynamics of the bubble instabilities are discussed. It was found that the new system could capture the main characteristics of all bubble instabilities quantitatively. It was also found that magnitude and periodicity of radius variation during draw resonance of LmPE decreased as TUR increased at constant FLH and BUR. This implies that the origin of draw resonance in film blowing seems to be different from that observed in fiber spinning. In the case of helicoidal instability, eccentricity, which defines the deviation of the bubble center from the die center, decreased as TUR increased. However, the bubble could not be stabilized as expected. A graphical quantification approach to determine the stable zone in the bubble stability map is also discussed.Keywords
This publication has 25 references indexed in Scilit:
- Extensional deformation, cohesive failure, and boundary conditions during sharkskin melt fractureJournal of Rheology, 2002
- Transient elongational viscosity of LLDPE/LDPE blends and its relevance to bubble stability in the film blowing processPolymer Engineering & Science, 1998
- Study of instabilities in film blowingAIChE Journal, 1996
- Multiplicities and instabilities in film blowingPolymer Engineering & Science, 1988
- Instrumentation development for sensing modes of bubble motion of a blown-film processAdvances in Polymer Technology, 1988
- A collaborative study of the stability of extrusion, melt spinning and tubular film extrusion of some high-, low- and linear-low density polyethylene samplesPure and Applied Chemistry, 1987
- Instability phenomena in tubular film, and melt spinning of rheologically characterized high density, low density and linear low density polyethylenesJournal of Non-Newtonian Fluid Mechanics, 1986
- Flow Instability in Tubular Film Blowing. 1. Experimental StudyIndustrial & Engineering Chemistry Fundamentals, 1977
- Stability of tubular film flow: a model of the film-blowing processJournal of Fluid Mechanics, 1976
- Studies on blown film extrusion. III. Bubble instabilityJournal of Applied Polymer Science, 1975