Design and implementation of perturbation observer‐based robust passivity‐based control for VSC‐MTDC systems considering offshore wind power integration
Authors:
Open Access
- 4 April 2018
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Generation, Transmission & Distribution
- Vol. 12 (10) , 2415-2424
Abstract
Voltage source converter‐based multi‐terminal high‐voltage direct current (VSC‐MTDC) systems are starting to be commissioned. However, concentrated integration of large‐scale wind power demands stronger robustness against power fluctuation and system disturbances to increase the reliability of the whole system. This study proposes a perturbation observer‐based robust passivity‐based control (PORPC) for VSC‐MTDC systems connected to an offshore wind farm to meet the demands. The aggregated effect of system nonlinearities, parameter uncertainties, unmodelled dynamics and external disturbances includes grid faults and time‐varying wind power output is estimated by a linear perturbation observer and fully compensated by a passive controller, thus no accurate VSC‐MTDC system model is required. PORPC attempts to regulate DC voltage and reactive power at the rectifier side, as well as active power and reactive power at the inverters side connected to an offshore wind farm. Besides, a DC‐link voltage droop controller is introduced so as to provide immediate response to the grid unbalance situation. Moreover, a noticeable robustness against parameter uncertainties can be achieved as no accurate system model is needed. Case studies are carried out to compare the performance of PORPC to other typical approaches. Finally, a hardware‐in‐the‐loop test is undertaken via dSPACE which validate its implementation feasibility.Keywords
This publication has 29 references indexed in Scilit:
- Nonlinear maximum power point tracking control and modal analysis of DFIG based wind turbineInternational Journal of Electrical Power & Energy Systems, 2016
- Perturbation estimation based coordinated adaptive passive control for multimachine power systemsControl Engineering Practice, 2015
- An FPGA-based real-time HIL test bench for full-bridge modular multilevel STATCOM controller2015
- Adaptive backstepping droop controller design for multi‐terminal high‐voltage direct current systemsIET Generation, Transmission & Distribution, 2015
- Passivity-Based Controller Design of Grid-Connected VSCs for Prevention of Electrical Resonance InstabilityIEEE Transactions on Industrial Electronics, 2014
- Perturbation Estimation Based Nonlinear Adaptive Control of a Full-Rated Converter Wind Turbine for Fault Ride-Through Capability EnhancementIEEE Transactions on Power Systems, 2014
- DC voltage control and power dispatch of a multi-terminal HVDC system for integrating large offshore wind farmsIET Renewable Power Generation, 2011
- Adaptive control design for VSC-HVDC systems based on backstepping methodElectric Power Systems Research, 2007
- Dynamic Model and Control of the NPC-Based Back-to-Back HVDC SystemIEEE Transactions on Power Delivery, 2005
- Reliability benefit analysis of adding WTG to a distribution systemIEEE Transactions on Energy Conversion, 2001