A Flexible Pressure Sensor Based on Low-Cost Electroplated-Ni Film Induced Cracking for Wearable Devices Application
Authors:
- 1 April 2018
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 432-435
Abstract
This paper reports a flexible pressure sensor based on electroplated-Ni film induced mechanical cracking that realizes the resistance change once undergoing pressure. A lot of cracks will be induced at the tip of triangle patterns due to the stress concentration when the sensor is pressed, which results in the resistance change with pressure. The test results show that the gauge factor of the fabricated pressure sensor reaches a maximum gauge factor of 24.2482 kPa -1 at 30.84 kPa. The fabricated pressure sensor has a response time of 18 ms and can even be applied in the wearable devices application, such as pulse detection.Keywords
This publication has 9 references indexed in Scilit:
- Graphene-Paper Pressure Sensor for Detecting Human MotionsACS Nano, 2017
- Recent advances in wearable tactile sensors: Materials, sensing mechanisms, and device performanceMaterials Science and Engineering: R: Reports, 2017
- Ultra-sensitive Pressure sensor based on guided straight mechanical cracksScientific Reports, 2017
- Wearable and flexible electronic strain sensorChinese Science Bulletin, 2016
- Pursuing prosthetic electronic skinNature Materials, 2016
- Advances of flexible pressure sensors toward artificial intelligence and health care applicationsMaterials Horizons, 2014
- A wearable and highly sensitive pressure sensor with ultrathin gold nanowiresNature Communications, 2014
- An ultra-sensitive resistive pressure sensor based on hollow-sphere microstructure induced elasticity in conducting polymer filmNature Communications, 2014
- Highly sensitive flexible pressure sensors with microstructured rubber dielectric layersNature Materials, 2010