Optical fiber taper sensor with a nanoparticles’ mixture cladding
- 15 March 2019
- conference paper
- Published by SPIE-Intl Soc Optical Eng
- Vol. 11045, 110450F
Abstract
Presented article shows the effect of using ZnS:Mn nanoparticles in the solution of higher alkanes on the light wave propagation in a biconical, adiabatic optical fiber taper. The used mixture of alkanes with nanoparticles forms a special cladding surrounding a fiber taper. Described studies show change of beam intensity depending on mixture temperature and its state of aggregation. Tests were carried out in a wide spectral range from the visible up to infrared wavelengths. The taper was made of a standard single-mode telecom fiber, pulled out to a length of 20.0 ± 0.5 mm and the diameter of the taper waist is 14.0 ± 0.2 μm. Such taper causes the beam to leak out of a waist structure and allows to add an external beam-controlling cladding material. The built-in sensor containing nanoparticles operates on the on-off principle. Nanoparticles added to the alkanes cause increase of hysteresis in a heating and cooling process. Such mixture makes also a significant shift of temperature characteristic in a heating process in which mixture change their physical state with a simultaneous slight shifting of the characteristics during cooling. Depending on the source used, weakening or amplification of the signal was obtained after switching to the liquid state.Keywords
This publication has 15 references indexed in Scilit:
- Optical Fiber Sensors Based on Nanoparticle-Embedded CoatingsJournal of Sensors, 2015
- Nonadiabatic tapered optical fiber for biosensor applicationsPhotonic Sensors, 2012
- The light emission properties of ZnS:Mn nanoparticlesThin Solid Films, 2011
- Synthesis, characterization and optical properties of water-soluble ZnS:Mn2+ nanoparticlesJournal of Luminescence, 2010
- Influence of tapering process on changes of optical fiber refractive index distribution along a structureOpto-Electronics Review, 2010
- Biconical Fiber Taper SensorsIEEE Photonics Technology Letters, 2006
- Tapered photonic crystal fibersOptics Express, 2004
- Optical devices based on liquid crystal photonic bandgap fibresOptics Express, 2003
- The shape of fiber tapersJournal of Lightwave Technology, 1992
- Nematic liquid crystal clad tapered optical fiber with temperature sensing propertiesJournal of Applied Physics, 1990