Research on Micro-CL Geometric Errors
Open Access
- 9 February 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 13, 124494-124503
Abstract
Computed laminography (CL) is a nondestructive testing technique for planar objects. It has been applied in applications like printed circuit board inspection and paleontological fossils research. However, the CL system calibration is a challenging task for complex mechanical structure and many degrees of freedom. To evaluated the influence of geometric errors, a new-type microscopic CL (micro-CL) with different kinds of geometric errors was simulated. The results can guide the installation and calibration of a micro-CL scanner.Keywords
Funding Information
- National Key Research and Development Program of China
- the Institute of High Energy Physics, Chinese Academy of Sciences
- National Key Research and Development Program of China (2017YFF0107201)
- CAS Interdisciplinary Innovation Team (JCTD-2019-02)
This publication has 15 references indexed in Scilit:
- Laminography in the lab: imaging planar objects using a conventional x-ray CT scannerMeasurement Science and Technology, 2019
- A micro-CL system and its applicationsReview of Scientific Instruments, 2017
- The ASTRA Toolbox: A platform for advanced algorithm development in electron tomographyUltramicroscopy, 2015
- Towards geometrical calibration of x-ray computed tomography systems—a reviewMeasurement Science and Technology, 2015
- A practical method to calibrate the slant angle of central X-ray for laminography scanning systemNDT & E International, 2014
- Calibration method of projection coordinate system for X-ray cone-beam laminography scanning systemNDT & E International, 2012
- Physical characterization and performance evaluation of an x-ray micro-computed tomography system for dimensional metrology applicationsMeasurement Science and Technology, 2012
- Neutron laminography—a novel approach to three-dimensional imaging of flat objects with neutronsNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2011
- Analysis of the effect of cone-beam geometry and test object configuration on the measurement accuracy of a computed tomography scanner used for dimensional measurementMeasurement Science and Technology, 2011
- Computed tomography for dimensional metrologyCIRP Annals, 2011