Freeform injection molding of functional ceramics by hybrid additive manufacturing
Authors:
- Kyriakos DidilisKDKyriakos Didilis
- Debora MaraniDMDebora Marani
- Uffe Ditlev BihletUBUffe Ditlev Bihlet
- Astri Bjørnetun HaugenAHAstri Bjørnetun Haugen
- Vincenzo EspositoVEVincenzo Esposito
Open Access
- 6 October 2022
- journal article
- research article
- Published by Elsevier in Additive Manufacturing
- Vol. 60
Abstract
No abstract availableKeywords
Funding Information
- Safran
- Villum Fonden (37520)
- Innovation Fund (9065-00196B)
- Horizon 2020 (849119)
- European Commission
- Horizon 2020
This publication has 50 references indexed in Scilit:
- The effect of forming stresses on the sintering of ultra-fine Ce0.9Gd0.1O2−δ powdersJournal of the European Ceramic Society, 2013
- Modeling Sintering of Multilayers Under Influence of GravityJournal of the American Ceramic Society, 2012
- Influence of powder morphology on properties of ceramic injection moulding feedstocksJournal of the European Ceramic Society, 2011
- Simulation of micro powder injection moulding: Powder segregation and yield stress effects during form fillingJournal of the European Ceramic Society, 2011
- Rapid fabrication of alumina-based ceramic cores for gas turbine blades by stereolithography and gelcastingJournal of Materials Processing Technology, 2009
- Constrained sintering: A delicate balance of scalesJournal of the European Ceramic Society, 2008
- Direct observation of mould cavity filling in ceramic injection mouldingJournal of the European Ceramic Society, 2008
- Re-investigation of synthesis of BaTiO3 by conventional solid-state reaction and oxalate coprecipitation route for piezoelectric applicationsCeramics International, 2007
- Water‐soluble photopolymers for rapid prototyping of cellular materialsJournal of Applied Polymer Science, 2005
- Residual stresses and cracking in large ceramic injection mouldings subjected to different solidification schedulesJournal of the European Ceramic Society, 2000