Solidification-driven orientation gradients in additively manufactured stainless steel
Authors:
- Andrew T. PolonskyAPAndrew T. Polonsky
- William C. LentheWLWilliam C. Lenthe
- McLean P. EchlinMEMcLean P. Echlin
- Veronica LivescuVLVeronica Livescu
- George T. GrayGGGeorge T. Gray
- Tresa M. PollockTPTresa M. Pollock
- 1 January 2020
- journal article
- research article
- Published by Elsevier in Acta Materialia
- Vol. 183, 249-260
Abstract
No abstract availableKeywords
Funding Information
- U.S. Department of War
- National Nuclear Security Administration
This publication has 65 references indexed in Scilit:
- Evolution of microstructure in laser deposited Al–11.28%Si alloySurface and Coatings Technology, 2012
- Elevated temperature material properties of stainless steel alloysJournal of Constructional Steel Research, 2010
- Bisque: a platform for bioimage analysis and managementBioinformatics, 2009
- A framework for automated analysis and simulation of 3D polycrystalline microstructures.Part 1: Statistical characterizationActa Materialia, 2008
- X-ray diffraction contrast tomography: a novel technique for three-dimensional grain mapping of polycrystals. I. Direct beam caseJournal of Applied Crystallography, 2008
- Single-step laser deposition of functionally graded coating by dual ‘wire–powder’ or ‘powder–powder’ feeding—A comparative studyApplied Surface Science, 2007
- Residual stresses in LENS® components using neutron diffraction and contour methodMaterials Science and Engineering: A, 2005
- Three-dimensional maps of grain boundaries and the stress state of individual grains in polycrystals and powdersJournal of Applied Crystallography, 2001
- The effect of laser power and traverse speed on microstructure, porosity, and build height in laser-deposited Ti-6Al-4VScripta Materialia, 2000
- Diagrams for laser materials processingActa Metallurgica et Materialia, 1992