Analysis of voltage distribution in stator winding of IGBT PWM inverter-fed induction motors
Authors:
- Dong-Hee KimDKDong-Hee Kim
- 1 January 2005
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 3 (21635137) , 945-950 vol. 3
Abstract
IGBT PWM inverter has been concerned that insulation breakdown and irregular voltage distribution on stator winding due to high rate of voltage rise (dv/dt) caused by high-frequency switching and impedance mismatch between inverter and motor. In this paper, voltage distribution in stator windings of induction motor driven by IGBT PWM inverter is studied. To analyze the irregular voltage of stator winding, high frequency parameter is computed by using finite element method (FEM). An equivalent circuit composed by distributed capacitances, inductance, and resistance is derived from these parameters. This equivalent circuit is then used for simulation in order to predict the voltage distribution among the turns and coils. The variable effect on rising time of the inverter and cable length on the voltage distribution is also presented. In order to experiment, an induction motor, 50 HP , with taps from one phase and a switching surge generator were built to consider the voltage distribution.Keywords
This publication has 6 references indexed in Scilit:
- Electrical stress and failure mechanism of the winding insulation in PWM-inverter-fed low-voltage induction motorsIEEE Transactions on Industrial Electronics, 2000
- Evaluation of motor power cables for PWM AC drivesIEEE Transactions on Industry Applications, 1997
- Interaction of drive modulation and cable parameters on AC motor transientsIEEE Transactions on Industry Applications, 1997
- Calculation of machine winding electrical parameters at high frequencies for switching transient studiesIEEE Transactions on Energy Conversion, 1996
- Transient effects in application of PWM inverters to induction motorsIEEE Transactions on Industry Applications, 1992
- A finite element technique for multiconductor cable parameters calculationIEEE Transactions on Magnetics, 1989