An Enhanced Interlayer Construction Strategy for High‐Frequency Copper Clad Laminates: Resolving the Contradiction between Signal Loss and Adhesion
- 13 September 2023
- journal article
- research article
- Published by Wiley in Advanced Materials Technologies
- Vol. 8 (23)
Abstract
In high‐frequency printed circuit boards (PCBs), there is an inherent contradiction between minimizing signal loss and maximizing adhesion strength. To tackle this issue, this work presents a simple approach by developing an enhanced interlayer through a two‐step process involving anodization/APTES (3‐aminopropyltriethoxysilane) treatment. The anodization yields micro/nano oxide structures with low surface roughness, thereby reducing the skin effect. One side of the enhanced interlayer is mechanically anchored and chemically bonded to copper foils, while the other side is coupled with bismaleimide/triazine‐based resins (BT resins), significantly augmenting the adhesion strength. Eight‐layer PCBs manufactured employing this method exhibit an insertion loss of −1.3553 dB in−1 at 32 GHz. Compared to two conventional brown oxide methods, the insertion loss is reduced by 7.80% and 3.24%, respectively, with a more substantial reduction observed at higher frequencies. The peel strength of samples ranges from 0.554 to 0.589 N mm−1, demonstrating maximum enhancements of 34.78% and 164.13% in comparison to the two brown oxide methods, respectively. Moreover, eight‐layer PCBs undergo lead‐free reflow soldering tests, solder float tests, and thermal fatigue tests without encountering any failures. Consequently, the proposed method holds significant practical significance in addressing the challenge associated with low signal loss and high adhesion strength in high‐frequency PCBs.Keywords
Funding Information
- National Natural Science Foundation of China (52275425)
- Natural Science Foundation of Guangdong Province (2021B1515020087)
- Key Technologies Research and Development Program (2019YFE0126300)
This publication has 36 references indexed in Scilit:
- Incorporation of Tin on copper clad laminate to increase the interface adhesion for signal loss reduction of high-frequency PCB laminationApplied Surface Science, 2017
- UV/ozone treatment for adhesion improvement of copper/epoxy interfaceJournal of Industrial and Engineering Chemistry, 2017
- Thermally Stable Siloxane Hybrid Matrix with Low Dielectric Loss for Copper-Clad Laminates for High-Frequency ApplicationsACS Applied Materials & Interfaces, 2016
- The chips are down for Moore’s lawNature, 2016
- Adhesion of sputter-deposited Cu/Ti film on plasma-treated polymer substrateThin Solid Films, 2016
- Study on brown oxidation process with imidazole group, mercapto group and heterocyclic compounds in printed circuit board industryJournal of Adhesion Science and Technology, 2015
- Selective adsorption of cationic dyes by UiO-66-NH2Applied Surface Science, 2015
- A Vapor-Phase Deposited Polymer Film to Improve the Adhesion of Electroless-Deposited Copper Layer onto Various Kinds of SubstratesLangmuir, 2014
- Fabrications of Hollow Nanocubes of Cu2O and Cu via Reductive Self-Assembly of CuO NanocrystalsLangmuir, 2006
- Low temperature bonded Cu/LCP materials for FPCs and their characteristicsIEEE Transactions on Components and Packaging Technologies, 2005