Feasibility Analysis of SMA-Based Damping Devices for Use in Seismic Isolation of Low-Rise Frame Buildings
Authors:
- 4 June 2018
- journal article
- research article
- Published by World Scientific Pub Co Pte Ltd in International Journal of Structural Stability and Dynamics
- Vol. 18 (06)
Abstract
For seismic isolated buildings, the isolators should be able to control peak deformation and have good restoring ability to return the building to its original position. Shape memory alloys (SMAs) are known for their properties of energy dissipation and deformation recovery, which make them appealing for use in isolation systems. To this end, the feasibility of SMA-based damping devices for use in an isolation system of low-rise frame buildings is studied in this paper. Numerical analyses were conducted and compared for buildings installed with SMA-based bearings (SMABs) and lead-rubber bearings (LRBs). A two-mass isolated frame building installed with these bearings was subjected to earthquakes corresponding to multilevel seismic hazards. The results show that the SMABs offer comparable seismic hazard mitigation efficacy to that of the LRBs while successfully restoring the building to the rest position after the earthquake. Furthermore, adding the energy dissipation capacity and properly using the strain hardening behavior of the SMAs are favorable for controlling isolation deformation while protecting the superstructure. The strain hardening behavior of the SMABs is beneficial for controlling deformation at the isolator level, which can still maintain isolation efficacy.Keywords
This publication has 37 references indexed in Scilit:
- Seismic Response Control Using Shape Memory Alloys: A ReviewJournal of Intelligent Material Systems and Structures, 2011
- Seismic assessment of bridge structures isolated by a shape memory alloy/rubber-based isolation systemSmart Materials and Structures, 2010
- Potential of superelastic Cu–Al–Mn alloy bars for seismic applicationsEarthquake Engineering & Structural Dynamics, 2010
- Seismic Performance Assessment of Steel Frames with Shape Memory Alloy Connections, Part II – Probabilistic Seismic Demand AssessmentJournal of Earthquake Engineering, 2010
- Seismic Performance Assessment of Steel Frames with Shape Memory Alloy Connections. Part I — Analysis and Seismic DemandsJournal of Earthquake Engineering, 2010
- Feasibility Assessment of an Innovative Isolation Bearing System with Shape Memory AlloysJournal of Earthquake Engineering, 2009
- Seismic isolation of bridges using isolation systems based on flat sliding bearingsBulletin of Earthquake Engineering, 2007
- A shape memory alloy-based reusable hysteretic damper for seismic hazard mitigationSmart Materials and Structures, 2007
- Shaking‐table tests on reinforced concrete frames with different isolation systemsEarthquake Engineering & Structural Dynamics, 2006
- Aseismic Base IsolationThe Shock and Vibration Digest, 1982