Optimisation of catalytic system for tar mitigation in biomass producer gas
- 12 June 2018
- journal article
- research article
- Published by Taylor & Francis in International Journal of Ambient Energy
- Vol. 41 (6) , 621-626
Abstract
The producer gas from biomass gasification is an upcoming power-generating technique for meeting the power requirements of the rural society. The performance of the biomass gasifier can be raised by mitigating tar in producer gas. Tar is highly carcinogenic and tends to condense at room temperature, which results in blocking and fouling of the downstream equipment. In this research, nano-structured SiO2-supported Ni pellets are used as catalysts to reduce the tar content in producer gas from a biomass gasifier. Further, Cerium (Ce) and Praseodymium (Pr) are reinforced with Ni–SiO2 pellets to improve the catalytic activity for tar mitigation. The Taguchi methodology is employed to rank and predict the optimal catalytic factor among the catalyst weight, gas feed rate (GF) and bed temperature (BT) for the tar cracking. The experimentation is done according to the L9 design table and the mathematical model for tar concentration is developed with the adequacy (R2) of 99.93%. The optimal catalytic system with 9 g of Pr, 0.01 l/s GF and 775°C of BT has reduced the tar concentration from 27 to 0.17 mg/Nm3, i.e. the efficiency of tar mitigation achieved is around 99.3%.Keywords
This publication has 7 references indexed in Scilit:
- Ni-Ce/SiO2 nanocomposite: Characterization and catalytic activity in the cracking of tar in biomass gasifiersEnergy Sources, Part A: Recovery, Utilization, and Environmental Effects, 2016
- Mechanical and Surface Morphological Investigation on Duplex Ageing Behaviour of Al (7075) Al–Zn–Mg–Cu AlloyJournal of Advanced Microscopy Research, 2015
- A review on conversion of biomass to biofuel by nanocatalystsBiofuel Research Journal, 2014
- Effective utilisation of low-density biomass in a downdraft gasifierInternational Journal of Ambient Energy, 2013
- Energy and exergy analysis of steam gasification of biomass materials: a comparative studyInternational Journal of Ambient Energy, 2013
- A Statistical Analysis of Optimization of Wear Behaviour of Al- Al2O3 Composites Using Taguchi TechniqueProcedia Engineering, 2013
- Review of Catalytic Conditioning of Biomass-Derived SyngasEnergy & Fuels, 2009