Investigation of the Surface Roughness and Surface Uniformity of a Hybrid Sandwich Structure after Machining
Open Access
Abstract
The parameters of surface roughness Ra, Rz and Rmax as well as surface topography Sa, Sz, Sp and Sv of the two-layer sandwich structure composed of an AW-2024 T3 aluminum alloy (Al) and a carbon-fiber-reinforced polymer (CFRP) were measured to determine an impact of the machining configuration (arrangement of the materials forming a sandwich structure) and the type of tool (presence of the tool coating) on the quality of the surface obtained through circumferential milling. The measurements revealed that milling produced different values of surface roughness for the aluminum alloy and the CFRP composite with values of 2D and 3D surface roughness being higher for the composite layer. The highest value of Ra of 1.10 µm was obtained for the surface of the CFRP composite using the CFRP/Al configuration and a TiAlN-coated tool. The highest values of the Rz (6.51 µm) and Rmax (8.85 µm) surface roughness parameters were also obtained for the composite layer using the same machining configuration and type of tool.Keywords
Funding Information
- Lublin University of Technology—Regional Excellence Initiative (030/RID/2018/19)
This publication has 36 references indexed in Scilit:
- Surface Roughness after Machining and Influence of Feed Rate on ProcessKey Engineering Materials, 2013
- Experimental delamination analyses of CFRPs using different drill geometriesComposites Part B: Engineering, 2013
- Micro-EDM of Carbon Fibre-Reinforced PlasticsProcedia CIRP, 2013
- Measurement and analysis of surface roughness in turning of aerospace titanium alloy (gr5)Measurement, 2012
- Occurrence and propagation of delamination during the machining of carbon fibre reinforced plastics (CFRPs) – An experimental studyComposites Science and Technology, 2011
- Debonding of composites structural insulated sandwich panelsJournal of Reinforced Plastics and Composites, 2010
- The effect of machining on surface integrity of titanium alloy Ti–6% Al–4% VJournal of Materials Processing Technology, 2005
- Damage and dimensional precision on milling carbon fiber-reinforced plastics using design experimentsJournal of Materials Processing Technology, 2005
- A genetic algorithmic approach for optimization of surface roughness prediction modelInternational Journal of Machine Tools and Manufacture, 2002
- Machining of Composite MaterialsCIRP Annals, 2002