Effect of processing methods and protein content of the concentrate on the properties of milk protein concentrate with 80% protein
Authors:
- 1 September 2018
- journal article
- research article
- Published by American Dairy Science Association in Journal of Dairy Science
- Vol. 101 (9) , 7702-7713
Abstract
In recent years, a large increase in the production of milk protein concentrates (MPC) has occurred. However, compared with other types of milk powders, few studies exist on the effect of key processing parameters on powder properties. In particular, it is important to understand if key processing parameters contribute to the poor solubility observed during storage of high-protein MPC powders. Ultrafiltration (UF) and diafiltration (DF) are processing steps needed to reduce the lactose content of concentrates in the preparation of MPC with a protein content of 80% (MPC80). Evaporation is sometimes used to increase the TS content of concentrates before spray drying, and some indications exist that inclusion of this processing step may affect protein properties. In this study, MPC80 powders were manufactured by 2 types of concentration methods: membrane filtration with and without the inclusion of an evaporation step. Different concentration methods could affect the mineral content of MPC powders, as soluble salts can permeate the UF membrane, whereas no mineral loss occurs during evaporation, although a shift in calcium equilibrium toward insoluble forms may occur at high protein concentration levels. It is more desirable from an energy efficiency perspective to use higher total solids in concentrates before drying, but concerns exist about whether a higher protein content would negatively affect powder functionality. Thus, MPC80 powders were also manufactured from concentrates that had 3 different final protein concentrations (19, 21, and 23%; made from 1 UF retentate using batch recirculation evaporation, a similar concentration method). After manufacture, powders were stored for 6 mo at 30°C to help understand changes in MPC80 properties that might occur during shelf-life. Solubility and foaming properties were determined at various time points during high-temperature powder storage. Inclusion of an evaporation step, as a concentration method, resulted in MPC80 that had higher ash, total calcium, and bound calcium (of rehydrated powder) contents compared to concentration with only membrane filtration. Concentration method did not significantly affect the bulk (tapped) density, solubility, or foaming properties of the MPC powders. Powder produced from concentrate with 23% protein content exhibited a higher bulk density and powder particle size than powder produced from concentrate that had 19% protein. The solubility of MPC80 powder was not influenced by the protein content of the concentrate. The solubility of all powders significantly decreased during storage at 30°C. Higher protein concentrations in concentrates resulted in rehydrated powders that had higher viscosities (even when tested at a constant protein concentration). The protein content of the concentrate did not significantly affect foaming properties. Significant changes in the mineral content are used commercially to improve MPC80 solubility. However, although the concentration method did produce a small change in the total calcium content of experimental MPC80 samples, this modification was not sufficiently large enough (<7%) to influence powder solubility.Keywords
This publication has 35 references indexed in Scilit:
- Storage induced changes to high protein powders: influence on surface properties and solubilityJournal of the Science of Food and Agriculture, 2011
- Foaming properties of milk: A review of the influence of composition and processingInternational Journal of Dairy Technology, 2010
- How surface composition of high milk proteins powders is influenced by spray-drying temperatureColloids and Surfaces B: Biointerfaces, 2010
- Native phosphocaseinate powder during storage: Lipids released onto the surfaceJournal of Food Engineering, 2009
- Interactions of milk proteins during the manufacture of milk powdersLe Lait, 2007
- Protein interactions in milk protein concentrate powdersInternational Dairy Journal, 2006
- Effects of storage temperature on the solubility of milk protein concentrate (MPC85)Food Hydrocolloids, 2006
- Measurement of the Yield Stress of Protein Foams by Vane RheometryJournal of Food Science, 2000
- Composition, microstructure and maturation of semi-hard cheeses from high protein ultrafiltered milk retentates with different levels of denatured whey proteinInternational Dairy Journal, 1995
- Standardized Procedure for Measuring Foaming Properties of Three Proteins, A Collaborative StudyJournal of Food Science, 1990