Calculation of infrared heating burners of a micronizer using biomethane
Open Access
- 15 May 2020
- journal article
- research article
- Published by FSBEI HE Voronezh State University of Engineering Technologies in Proceedings of the Voronezh State University of Engineering Technologies
- Vol. 82 (1) , 17-26
Abstract
Studies have been carried out on the purification of biogas from sulfur compounds, carbon dioxide and water vapor for subsequent use in micronizer burners. The possibility of bringing it to the parameters of natural gas of the following composition: methane (CH4) – 85 % vol., carbon dioxide СО2 – 11 % vol., water vapor – 9 mg/m3, hydrogen sulfide H2S - 20 mg/m3 with minimal energy costs for its preparation is demonstrated. The basic relationships are obtained for assessing the design and technological parameters of the infrared radiation burners operation. Experimental studies of the flame stability limits on perforated ceramic nozzles have shown that flashback through them is possible when the thermal power is increased to a certain critical value. In this case, the thermal power depends on the type of gas and the air content in the combustible mixture. The heat balance equations have been derived to optimize the designs and operation modes of infrared radiation burners. The design of 40 gas burners was improved by changing the geometric dimensions and shape for a uniform distribution of biogas supplied and sustainable combustion over the entire area of the burner. It was established that the temperature of the heating surface of the GIK-8 burner on gas mixtures with a CO2 content of 18-34 % is 900-950 ° C, which does not differ from the nominal temperature when operating on natural gas. The infrared heating system was modernized, adapted for burning purified biogas with methane content up to 98 %, in particular, the biomethane feed and control system, the additional biogas input system, and the automatic burner control system were improved.Keywords
This publication has 10 references indexed in Scilit:
- ЭКОЛОГИЧЕСКИЕ ХАРАКТЕРИСТИКИ РАДИАЦИОННЫХ ГОРЕЛОК С ПОЛЫМ ЦИЛИНДРИЧЕСКИМ ИЗЛУЧАТЕЛЕМGorenie i vzryv (Moskva) - Combustion and Explosion, 2018
- INFRARED BURNING DEVICES WITH THE CATALYTIC RADIATION SCREENGorenie i vzryv (Moskva) - Combustion and Explosion, 2018
- CYLINDRICAL RADIANT BURNERS WITH MAXIMAL RADIATION EFFICIENCYGorenie i vzryv (Moskva) - Combustion and Explosion, 2018
- Thermophotovoltaic power conversion using a superadiabatic radiant burnerApplied Energy, 2018
- Experimental study of the combustion of natural gas and high-hydrogen content syngases in a radiant porous media burnerInternational Journal of Hydrogen Energy, 2017
- Application and development of biogas technology for the treatment of waste in ChinaRenewable and Sustainable Energy Reviews, 2017
- Effects of the preheat layer thickness on surface/submerged flame during porous media combustion of micro burnerEnergy, 2017
- Ultra-low calorific gas combustion in a gradually-varied porous burner with annular heat recirculationEnergy, 2017
- Flame anchoring regime of filtrational gas combustion: Theory and experimentProceedings of the Combustion Institute, 2017
- Numerical analysis on the transient measurement of gas temperature in porous material using thermocouples at high temperaturesInternational Journal of Heat and Mass Transfer, 2015