Effect of an additional hydrophilic versus hydrophobic coat on the quality of dentinal sealing provided by two-step etchand-rinse adhesives
Open Access
- 1 June 2009
- journal article
- research article
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 17 (3) , 184-189
Abstract
To test the hypothesis that the quality of the dentinal sealing provided by two-step etch-and-rinse adhesives cannot be altered by the addition of an extra layer of the respective adhesive or the application of a more hydrophobic, non-solvated resin. full-crown preparations were acid-etched with phosphoric acid for 15 s and bonded with Adper Single Bond (3M ESPE), Excite DSC (Ivoclar/Vivadent) or Prime & Bond NT (Dentsply). The adhesives were used according to the manufacturers' instructions (control groups) or after application to dentin they were a) covered with an extra coat of each respective system or b) coated with a non-solvated bonding agent (Adper Scotchbond Multi-Purpose Adhesive, 3M ESPE). Fluid flow rate was measured before and after dentin surfaces were acid-etched and bonded with adhesives. None of the adhesives or experimental treatments was capable to block completely the fluid transudation across the treated dentin. Application of an extra coat of the adhesive did not reduce the fluid flow rate of adhesive-bonded dentin (p>0.05). Conversely, the application of a more hydrophobic non-solvated resin resulted in significant reductions in the fluid flow rate (p<0.05) for all tested adhesives. The quality of the dentinal sealing provided by etch-and-rinse adhesives can be significantly improved by the application of a more hydrophobic, non-solvated bonding agent.Keywords
This publication has 31 references indexed in Scilit:
- Bonding BisGMA to Dentin—a Proof of Concept for Hydrophobic Dentin BondingJournal of Dental Research, 2007
- Dentine sealing provided by smear layer/smear plugs vs. adhesive resins/resin tagsEuropean Journal of Oral Sciences, 2007
- Relationship between water status in dentin and interfacial morphology in all-in-one adhesivesDental Materials, 2007
- Water sorption/solubility of dental adhesive resinsDental Materials, 2006
- Hygroscopic and hydrolytic effects in dental polymer networksDental Materials, 2006
- Solvent and water retention in dental adhesive blends after evaporationBiomaterials, 2005
- Fluid Movement across the Resin-Dentin Interface during and after BondingJournal of Dental Research, 2004
- Single-bottle adhesives behave as permeable membranes after polymerization. I. In vivo evidenceJournal of Dentistry, 2004
- Adhesive phase separation at the dentin interface under wet bonding conditionsJournal of Biomedical Materials Research, 2002
- Some effects of water on dentin bondingDental Materials, 1995