Evaluation of Surface Treatment for Enhancing Adhesion at the Metal–Composite Interface in Fibre Metal-Laminates
Open Access
- 3 September 2022
- Vol. 15 (17) , 6118
Abstract
The paper presents the issues of metal surface treatment in fibre metal laminates (FML) to obtain high adhesion at the metal–composite interface. Aluminium 2024-T3 and titanium Grade 2 were analysed. The metal surface modifications were carried out by mechanical (sandblasting, Scotch-Brite abrasion), chemical (P2 etching, phosphate-fluoride process), electrochemical (chromic and sulphuric acid anodizing), and plasma treatment, as well as the application of sol-gel coatings. In terms of surface geometry, the analysis included roughness and 3D surface topography examination. The morphology was examined using scanning electron and atomic force microscopy. The surface free energy and its components (polar and dispersive) were determined using the Owens–Wendt method. The novelty of this study is the determination of the effect of different surface treatments on the surface free energy, topography, and morphology in terms of the possible appropriate adhesion in fibre metal laminates. Chromic acid anodizing is still the most effective in enhancing the expected adhesion. A suitable technique may be the use of P2 etching of aluminium. It results in low roughness, numerous micro-irregularities, and the presence of porosity. The obtained test results show that the application of sol-gel coating increases the surface free energy and may increase the adhesion.Keywords
Funding Information
- Lublin University of Technology, Doctoral School
This publication has 54 references indexed in Scilit:
- Recent Trends in Surface Treatment Technologies for Airframe Adhesive Bonding Processing: A Review (1995–2008)The Journal of Adhesion, 2010
- Hygrotermal effects evaluation using the iosipescu shear test for glare laminatesJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2008
- Strategies for the replacement of chromic acid anodising for the structural bonding of aluminium alloysInternational Journal of Adhesion and Adhesives, 2006
- A review on the development and properties of continuous fiber/epoxy/aluminum hybrid composites for aircraft structuresMaterials Research, 2006
- Effect of Surface Morphology on Crack Growth at a Sol-Gel Reinforced Epoxy/Aluminum InterfaceThe Journal of Adhesion, 2006
- Surface energy, surface topography and adhesionInternational Journal of Adhesion and Adhesives, 2003
- The effects of grit-blasting on surface properties for adhesionInternational Journal of Adhesion and Adhesives, 1999
- Optimization of Surface Treatment and Adhesive Selection for Bond Durability in Ti-15-3 LaminatesThe Journal of Adhesion, 1999
- The effect of adhesive bonding between aluminum and composite prepreg on the mechanical properties of carbon-fiber-reinforced metal laminatesComposites Science and Technology, 1997
- Oxide morphologies on aluminum prepared for adhesive bondingApplications of Surface Science, 1979