Numerical Analysis of Effect of Operation Conditions on Bubble Distribution in Steel Continuous Casting Mold with Advanced Bubble Break-up and Coalescence Models
Authors:
Open Access
- 15 October 2020
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 60 (10) , 2234-2245
Abstract
Argon bubbles are usually injected into steel continuous casting mold to prevent the clogging of submerged entry nozzle (SEN), but some bubbles may be entrapped to form defects in the final slab. In order to provide a reference for improving the quality of steel, a mathematical model based on the Eulerian-Lagrangian approach with advanced bubble break-up and coalescence models was established to study the effect of operation conditions on bubble distribution in a steel continuous casting mold. A bubble break-up model based on a daughter bubble fraction, which is suitable for the continuous casting system, was considered. The mathematic model was validated by comparing of the size and number of captured bubbles with the plant measurements of previous work. The result shows that argon gas injection has obvious effect on the flow pattern in the upper recirculation zone of the mold. In the upper recirculation zone, the bubbles mean diameter decreases and the bubble number increases with increasing casting speed, and both of the bubble size and number increase with the increase of gas flow rate. From the result, it can be found that the number and diameter of bubbles arriving at the advancing solidified shell region increase with increasing casting speed. In addition, the increase of gas flow rate causes more bubbles arriving at the advancing solidified shell region, but has little effect on the size of bubbles.Keywords
This publication has 32 references indexed in Scilit:
- Multiscale modeling of particle–solidification front dynamics, Part I: MethodologyInternational Journal of Heat and Mass Transfer, 2007
- The effect of electrolytes on the critical velocity for bubble coalescenceChemical Engineering Journal, 2007
- On the effect of liquid temperature upon bubble coalescenceChemical Engineering Science, 2006
- Influence of argon gas bubbles and non-metallic inclusions on the flow behavior in steel continuous castingMaterials Science and Engineering: A, 2005
- Dynamics of two-phase downwards flows in submerged entry nozzles and its influence on the two-phase flow in the moldInternational Journal of Multiphase Flow, 2005
- Interaction between Argon Gas Bubbles and Solidified ShellISIJ International, 2004
- A novel theoretical breakup kernel function for bubbles/droplets in a turbulent flowChemical Engineering Science, 2003
- Two-phase Flow Numerical Simulation of Molten Steel and Argon Gas in a Continuous Casting Mold.ISIJ International, 2002
- A new model for the breakage frequency of drops in turbulent stirred dispersionsChemical Engineering Science, 1992
- Bubble coalescence in pure liquids1982