Hot tearing and mechanical properties of high electrical and thermal conductivity Al-Fe-Mg-Si-Ni Alloys
- 2 November 2022
- journal article
- research article
- Published by Taylor & Francis in International Journal of Cast Metals Research
- Vol. 35 (5-6) , 187-205
Abstract
Aluminium alloys with Fe and Ni show potential as high castability alloys with high strength and high electrical/thermal conductivities for electric vehicle powertrains. Permanent mould castings of Al-Fe-Ni alloys with additions of Mg and Si were prepared to assess hot tearing susceptibility and mechanical properties. The electrical conductivity of the Al-Fe-Ni alloys was measured, and the Wiedemann-Franz law was used to estimate the thermal conductivity. The results show that a hot tear resistant Al-Fe-Ni alloy with composition Al-1.2Fe-0.5Mg-0.3Si-0.2Ni had an electrical conductivity of 50.91 ±0.29%IACS with yield strength, ultimate tensile strength, and elongation of 60.5 MPa, 141 MPa and 7.9%, respectively. The microstructure of the Al-Fe-Ni alloys contained primary Al, Al9FeNi and Mg2Si. The short freezing ranges and fine intermetallics allowed for good castability. The prepared Al-Fe-Ni alloys are potential new castable Al alloys that have thermal and electrical conductivity nearing wrought (6061 and 6101) compositions.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada
This publication has 41 references indexed in Scilit:
- The Effect of Alloying Elements on Thermal Conductivity of Aluminum Alloys in High Pressure Die CastingAdvanced Materials Research, 2013
- Management of Impurities in Cast House with Particular Reference to Ni and V2013
- The effect of main alloying elements on the physical properties of Al–Si foundry alloysMaterials Science and Engineering: A, 2013
- Sparingly alloyed high-strength aluminum alloys: principles of optimization of phase compositionMetal Science and Heat Treatment, 2012
- An overview on phase equilibria and thermodynamic modeling in multicomponent Al alloys: Focusing on the Al–Cu–Fe–Mg–Mn–Ni–Si–Zn systemCalphad, 2011
- A study of tensile properties in Al–Si–Cu and Al–Si–Mg alloys: Effect of β-iron intermetallics and porosityMaterials Science and Engineering: A, 2008
- Thermal characteristics of heat-treated aluminum high-pressure die-castingsScripta Materialia, 2008
- Thermodynamic description of the Al–Fe–Ni system over the whole composition and temperature ranges: Modeling coupled with key experimentCalphad, 2007
- Thermodynamic calculation as a tool for thixoforming alloy and process developmentMaterials Science and Engineering: A, 2006
- Mechanical properties in the semi-solid state and hot tearing of aluminium alloysProgress in Materials Science, 2004