Research on Void Dynamics during In Situ Consolidation of CF/High-Performance Thermoplastic Composite
Open Access
Abstract
Automated fiber placement (AFP) in situ consolidation of continuous CF/high-performance thermoplastic composite is the key technology for efficient and low-cost manufacturing of large thermoplastic composites. However, the void in the in situ composite is difficult to eliminate because of the high pressure and the short consolidation time; the void content percentage consequently is the important defect that determines the performance of the thermoplastic composite parts. In this paper, based on the two-dimensional Newtonian fluid extrusion flow model, the void dynamics model and boundary conditions were established. The changes of the void content percentage were predicted by the cyclic iteration method. It was found that the void content percentage increased gradually along the direction of the layers’ thickness. With the increasing of the laying speed, the void content percentage increased gradually. With the increasing of the pressure of the roller, the void content percentage gradually decreased. When the AFP speed was 11 m/min and the pressure of the compaction roller reached 2000 N, the void content percentage of the layers fell below 2%. It was verified by the AFP test that the measured results of the layers’ thickness were in good agreement with the predicted results of the model, and the test results of the void content percentage were basically equivalent to the predicted results at different AFP speeds, which indicates that the kinetic model established in this paper is representative to predict the void content percentage. According to the metallographic observation, it was also found that the repeated pressure of the roller was helpful to reduce the void content percentage.Keywords
Funding Information
- Shanghai Collaborative Innovation Center of HighPerformance Fibers and Composites (Province-Minitry Joint) (X12812101/022)
- Shanghai Sailing Program (19YF1417100)
- Commercial Aircraft Corporation of China, Ltd. (COMAC) innovation funds (Y20GS14)
- Project of China’s Ministry of Science and Technology (2020YFB0311500)
This publication has 31 references indexed in Scilit:
- Shear bond strength of composite resin to high performance polymer PEKK according to surface treatments and bonding materialsThe Journal of Advanced Prosthodontics, 2017
- Ultrasonic consolidation of thermoplastic composite prepreg for automated fiber placementJournal of Thermoplastic Composite Materials, 2016
- Mechanical characterisation of carbon fibre–PEEK manufactured by laser-assisted automated-tape-placement and autoclaveComposites Part A: Applied Science and Manufacturing, 2015
- In situ consolidation of thermoplastic prepreg tape using automated tape placement technology: Potential and possibilitiesComposites Part B: Engineering, 2014
- Optimization of the tape placement process parameters for carbon–PPS compositesComposites Part A: Applied Science and Manufacturing, 2013
- Transmission laser welding of amorphous and semi-crystalline poly-ether–ether–ketone for applications in the medical device industryMaterials & Design (1980-2015), 2010
- Modeling of In Situ Strength Development for the Thermoplastic Composite Tow Placement ProcessJournal of Composite Materials, 2006
- Compounding and molding of polyethylene composites reinforced with keratin feather fiberComposites Science and Technology, 2005
- Transverse flow processes in continuous fibre-reinforced thermoplastic compositesComposites, 1989
- Modelling transverse flows of reinforced thermoplastic materialsComposites, 1989