New hat feed for reflector antennas realised without dielectrics for reducing manufacturing cost and improving reflection coefficient
Authors:
- 13 May 2011
- journal article
- Published by Institution of Engineering and Technology (IET) in IET Microwaves, Antennas & Propagation
- Vol. 5 (7) , 837-843
Abstract
This study presents a new hat feed that is made entirely of metal without using dielectric material. Compared to previous hat feeds where a piece of dielectric is used to support the hat on the waveguide, the new feed has lower manufacturing cost and higher reliability. In addition, the new hat feed has low radiation along the feeding waveguide, which makes the vertex plate unnecessary. Therefore the bandwidth over which the reflection coefficient magnitude is below −15 dB has increased. The feed has been optimised using a genetic algorithm. A prototype has been manufactured, and measured results are presented to verify the numerical simulations.Keywords
This publication has 6 references indexed in Scilit:
- Analysis and design of a novel hat feed with narrow beamwidth for the Fresnel zone plate antennaInternational Journal of RF and Microwave Computer-Aided Engineering, 2009
- High performance reflector hat antenna with very low sidelobes for radio-link applications2002
- Calculation of ring-shaped phase centers of feeds for ring-focus paraboloidsIEEE Transactions on Antennas and Propagation, 2000
- Gaussian vertex plate improves return loss and far-out sidelobes in prime-focus reflector antennasMicrowave and Optical Technology Letters, 1999
- Classification of Rotationally Symmetric Antennas as Types BOR /sub 0/ and BOR /sub 1/IEEE Antennas and Propagation Magazine, 1995
- The hat feed: A dual-mode rear-radiating waveguide antenna having low cross polarizationIEEE Transactions on Antennas and Propagation, 1987