A Practical Switching Loss Model for Buck Voltage Regulators
Authors:
- 20 January 2009
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 24 (3) , 700-713
Abstract
In this paper, a review of switching loss mechanisms for synchronous buck voltage regulators (VRs) is presented. Following the review, a new simple and accurate analytical switching loss model is proposed for synchronous buck VRs. The model includes the impact of common source inductance and switch parasitic inductances on switching loss. The proposed model uses simple equations to calculate the rise and fall times and piecewise linear approximations of the high-side MOSFET voltage and current waveforms to allow quick and accurate calculation of switching loss in a synchronous buck VR. A simulation program with integrated circuit emphasis (Spice) simulations are used to demonstrate the accuracy of the voltage source driver model operating in a 1-MHz synchronous buck VR at 12-V input, 1.3-V output. Switching loss was estimated with the proposed model and compared to Spice measurements. Experimental results are presented to demonstrate the accuracy of the proposed model.Keywords
This publication has 12 references indexed in Scilit:
- Optimal Design of Resonant Gate Driver for Buck Converter Based on a New Analytical Loss ModelIEEE Transactions on Power Electronics, 2008
- A Current Source Gate Driver Achieving Switching Loss Savings and Gate Energy Recovery at 1-MHzIEEE Transactions on Power Electronics, 2008
- Characterization of $Cdv/dt$ Induced Power Loss in Synchronous Buck DC–DC ConvertersIEEE Transactions on Power Electronics, 2007
- VR Transient Improvement at High Slew Rate Load—Active Transient Voltage CompensatorIEEE Transactions on Power Electronics, 2007
- A New Resonant Gate Drive Circuit for Synchronous Buck ConverterIEEE Transactions on Power Electronics, 2007
- A High Efficiency Synchronous Buck VRM with Current Source Gate Driver2007
- Optimal Design of Current Source Gate Driver for a Buck Voltage Regulator Based on a New Analytical Loss Model2007
- Multifrequency Small-Signal Model for Buck and Multiphase Buck ConvertersIEEE Transactions on Power Electronics, 2006
- Tapped-Inductor Buck Converter for High-Step-Down DC–DC ConversionIEEE Transactions on Power Electronics, 2005
- A novel resonant gate driver for high frequency synchronous buck convertersIEEE Transactions on Power Electronics, 2002