Diffusion brazing of cast INCONEL 718 superalloy utilising standard heat treatment cycle
Authors:
- 1 January 2014
- journal article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 30 (1) , 109-115
Abstract
The time required to ensure completion of the isothermal solidification process is the key in obtaining an intermetallic free and robust joint after diffusion brazing. In view of economic considerations, it is interesting to perform bonding process trials using standard heat treatment cycles. This paper addresses the effect of applying the standard heat treatment cycle including homogenisation, solution and double aging treatments on the microstructural and mechanical response of diffusion brazed IN718. A commercial Ni–7Cr–4·5Si–3·2B–3Fe (wt-) brazing alloy was used as the interlayer. Results showed that bonds made with the standard homogenisation treatment, at 1100°C, exhibited a eutectic free joint centreline. After applying the standard solution and double aging treatment, a bond with a joint efficiency of 82 relative to base metal was obtained in terms of shear strength. Room temperature tensile properties and stress rupture properties of the diffusion brazed joint were better than the minimum requirement of the AMS5383 acceptance standard.Keywords
This publication has 16 references indexed in Scilit:
- Transient liquid phase bonding of wrought IN718 nickel based superalloy using standard heat treatment cycles: Microstructure and mechanical propertiesMaterials & Design (1980-2015), 2013
- Solidification and solid state phenomena during TLP bonding of IN718 superalloy using Ni–Si–B ternary filler alloyJournal of Alloys and Compounds, 2013
- TLP bonding of cast IN718 nickel based superalloy: Process–microstructure–strength characteristicsMaterials Science and Engineering: A, 2013
- Effect of serrated grain boundaries on the creep property of Inconel 718 superalloyMaterials Science and Engineering: A, 2011
- Understanding reversed temperature dependence of diffusional solidification time in single crystal superalloy brazementPhilosophical Magazine, 2011
- Effect of pre- and post-weld heat treatment on metallurgical and tensile properties of Inconel 718 alloy butt joints welded using 4 kW Nd:YAG laserJournal of Materials Science, 2009
- Microstructure development during transient liquid phase bonding of GTD-111 nickel-based superalloyJournal of Alloys and Compounds, 2008
- Transient liquid phase bondingScience and Technology of Welding and Joining, 2004
- Isothermal solidification kinetics of diffusion brazingMetallurgical and Materials Transactions A, 1998
- Role of brazing in repair of superalloy components – advantages and limitationsMaterials Science and Technology, 1985