On the Effect of Thermal Energy Transport to the Performance of (Semi) Floating Ring Bearing Systems for Automotive Turbochargers
Authors:
- 22 August 2012
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 134 (10) , 102507
Abstract
Bearing systems in engine-oil lubricated turbochargers (TCs) must operate reliably over a wide range of shaft speeds and withstand severe axial and radial thermal gradients. An engineered thermal management of the energy flows into and out of the bearing system is paramount in order to ensure the component’s mechanical integrity and the robustness of the bearing system. The bearings, radial and thrust type, act both as a load bearing and low friction support with the lubricant carrying away a large fraction of the thermal energy generated by rotational drag and the heat flow disposed from a hot shaft. The paper introduces a thermohydrodynamic analysis for the prediction of the pressure and temperature fields in a (semi) floating ring bearing (S)FRB system. The analysis simultaneously solves the Reynolds equation with variable oil viscosity and the thermal energy transport equation in the inner and outer films of the bearing system. Flow conditions in both films are coupled to the temperature distribution and heat flow through the (semi) floating ring. Other constraints include calculating the fluid films’ forces reacting to the externally applied load and to determine the operating journal and ring eccentricities. The predictions of performance for a unique realistic (S)FRB configuration at typical TC operating conditions reveal a distinct knowledge: (a) the heat flow from the shaft into the inner film is overwhelming, in particular, at the inlet lubricant plane where the temperature difference with the cold oil is largest; (b) the inner film temperature quickly increases as soon as the (cold) lubricant enters the film and is due to the large amount of energy generated by shear drag and the heat transfer from the shaft; (c) a floating ring develops a significant radial temperature gradient; (d) at all shaft speeds, low and high, the thermal energy carried away by the lubricant streams is no less than 70% of the total energy input; the rest is conducted through the TC casing. To warrant this thermal energy distribution, enough lubricant flow must be supplied to the bearing system. The efficient computational model offers a distinct advantage over existing lumped parameters thermal models and there is no penalty in the execution time.Keywords
This publication has 15 references indexed in Scilit:
- CFD model for turbocharger journal bearing performancesApplied Thermal Engineering, 2011
- Nonlinear Dynamic Behavior of Turbocharger Rotor-Bearing Systems With Hydrodynamic Oil Film and Squeeze Film Damper in Series: Prediction and ExperimentJournal of Computational and Nonlinear Dynamics, 2010
- The Analysis of Heat Transfer in Automotive TurbochargersJournal of Engineering for Gas Turbines and Power, 2010
- Turbocharger Nonlinear Response With Engine-Induced Excitations: Predictions and Test DataJournal of Engineering for Gas Turbines and Power, 2009
- Aeration effects on the performance of a turbocharger journal bearingTribology International, 2008
- A Virtual Tool for Prediction of Turbocharger Nonlinear Dynamic Response: Validation Against Test DataJournal of Engineering for Gas Turbines and Power, 2006
- Test Response and Nonlinear Analysis of a Turbocharger Supported on Floating Ring BearingsJournal of Vibration and Acoustics, 2005
- Thermal effects on the performance of floating ring bearings for turbochargersProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 2004
- The inclusion of lubricant shear thinning in the short bearing approximationProceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology, 1999
- Thermal Effects in Cryogenic Liquid Annular Seals—Part I: Theory and Approximate SolutionJournal of Tribology, 1993