Properties of Foamed Mortar Prepared with Granulated Blast-Furnace Slag
Open Access
- 30 January 2015
- Vol. 8 (2) , 462-473
Abstract
Foamed mortar with a density of 1300 kg/m3 was prepared. In the initial laboratory trials, water-to-cement (w/c) ratios ranging from 0.54 to 0.64 were tested to determine the optimal value for foamed mortar corresponding to the highest compressive strength without compromising its fresh state properties. With the obtained optimal w/c ratio of 0.56, two types of foamed mortar were prepared, namely cement-foamed mortar (CFM) and slag-foamed mortar (SFM, 50% cement was replaced by slag weight). Four different curing conditions were adopted for both types of foamed mortar to assess their compressive strength, ultrasonic pulse velocity (UPV) and thermal insulation performance. The test results indicated that utilizing 50% of slag as cement replacement in the production of foamed mortar improved the compressive strength, UPV and thermal insulation properties. Additionally, the initial water curing of seven days gained higher compressive strength and increased UPV values as compared to the air cured and natural weather curing samples. However, this positive effect was more pronounced in the case of compressive strength than in the UPV and thermal conductivity of foamed mortar.Keywords
Funding Information
- State Key Laboratory of Geohazard Prevention and Geoenvironment Protection (SKLGP2012K002)
This publication has 9 references indexed in Scilit:
- Properties and sustainability of alkali-activated slag foamed concreteJournal of Cleaner Production, 2014
- A classification of studies on properties of foam concreteCement and Concrete Composites, 2009
- GGBFS as potential filler in polyester grout: Flexural strength and toughnessConstruction and Building Materials, 2009
- Effects of mineral admixtures on fresh and hardened properties of self-compacting concretes: binary, ternary and quaternary systemsMaterials and Structures, 2007
- Heat of hydration in foamed concrete: Effect of mix constituents and plastic densityCement and Concrete Research, 2006
- Influence of filler type on the properties of foam concreteCement and Concrete Composites, 2006
- Preliminary views on the potential of foamed concrete as a structural materialMagazine of Concrete Research, 2005
- Ash content for optimum strength of foamed concreteCement and Concrete Research, 2002
- The effect of high fly ash content on the compressive strength of foamed concreteCement and Concrete Research, 2001