Influence of Scanning Speed on Microstructure and Properties of Laser Cladded Fe-Based Amorphous Coatings
Open Access
Abstract
Fe-based amorphous alloys with excellent mechanical properties are suitable for preparing wear resistant coatings by laser cladding. In this study, a novel Fe-based amorphous coating was prepared by laser cladding on 3Cr13 stainless steel substrates. The influence of scanning speeds on the microstructures and properties of the coatings was investigated. The microstructure compositions and phases were analyzed by scanning electron microscope, electron probe microanalyzer, and x-ray diffraction respectively. Results showed that the microstructures of the coatings changed significantly with the increase of scanning speeds. For a scanning speed of 6 mm/s, the cladding layer was a mixture of amorphous and crystalline regions. For a scanning speed of 8 mm/s, the cladding layer was mainly composed of block grain structures. For a scanning speed of 10 mm/s, the cladding layer was composed entirely of dendrites. Different dilution rates at the bonding zones were the main reasons for the microstructure change for different claddings. For all three scanning speeds, the coatings had higher hardness and wear resistance when compared with the substrate; as the scanning speed increased, the hardness and wear resistance of the coatings gradually decreased due to the change in microstructure.Keywords
Funding Information
- National Natural Science Foundation of China (51675303)
- the Tribology Science Fund of the State Key Laboratory of Tribology (SKLT2018B05)
This publication has 30 references indexed in Scilit:
- Effect of Laser Power on the Cladding Temperature Field and the Heat Affected ZoneJournal of Iron and Steel Research International, 2011
- Formation of amorphous Zr41.2Ti13.8Ni10Cu12.5Be22.5 coatings via the ElectroSpark Deposition processIntermetallics, 2008
- Laser surface coating of Fe–Cr–Mo–Y–B–C bulk metallic glass composition on AISI 4140 steelSurface and Coatings Technology, 2008
- Laser cladding of Zr65Al7.5Ni10Cu17.5 amorphous alloy on magnesiumMaterials Letters, 2007
- Microstructure and properties of laser clad Zr-based alloy coatings on Ti substratesSurface and Coatings Technology, 2004
- Synthesis of thick Ni66Cr5Mo4Zr6P15B4 amorphous alloy coating and large glass-forming ability by laser claddingMaterials Letters, 2002
- Fe-based thick amorphous-alloy coating by laser claddingSurface and Coatings Technology, 2001
- The microstructure and tribological characteristics of laser-clad Ni–Cr–Al coatings on aluminium alloyMaterials Science and Engineering: A, 2000
- Mechanical strength and thermal stability of Ti-based amorphous alloys with large glass-forming abilityMaterials Science and Engineering: A, 1994
- Laser-processed corrosion-resistant amorphous NiCrPB surface alloys on a mild steelCorrosion Science, 1987