Picomolar detection of mercury (II) using a three-dimensional porous graphene/polypyrrole composite electrode
- 13 May 2014
- journal article
- Published by Springer Nature in Analytical and Bioanalytical Chemistry
- Vol. 406 (27) , 6953-6956
Abstract
A polypyrrole (PPy)-functionalized three-dimensional (3D) porous electrode of electrochemically reduced graphene oxide (ErGO) has been prepared by electrochemical deposition. This PPy-modified 3D-ErGO electrode was used for the electrochemical detection of Hg2+ ions, and it exhibited high sensitivity and selectivity. Furthermore, the limit of detection (LOD) was measured to be as low as 0.03 nM (30 ppt), and this value is much lower than the guideline value of 2 ppb for drinking water given by the World Health Organization.Keywords
This publication has 5 references indexed in Scilit:
- The edge- and basal-plane-specific electrochemistry of a single-layer graphene sheetScientific Reports, 2013
- Ultrahigh-rate supercapacitors based on eletrochemically reduced graphene oxide for ac line-filteringScientific Reports, 2012
- Selective adsorption toward toxic metal ions results in selective response: electrochemical studies on a polypyrrole/reduced graphene oxide nanocompositeChemical Communications, 2011
- Sources and remediation for mercury contamination in aquatic systems—a literature reviewEnvironmental Pollution, 2004
- The standard potentials of the electrode “dissolved atomic mercury/dissolved mercury ions”Electroanalysis, 1996