Biomechanical Evaluation of Arthroscopic Rotator Cuff Repairs
Authors:
- C. Benjamin MaCMC. Benjamin Ma
- Lyn ComerfordLCLyn Comerford
- Joseph WilsonJWJoseph Wilson
- Christian M. PuttlitzCPChristian M. Puttlitz
- 1 February 2006
- journal article
- research article
- Published by Wolters Kluwer Health in Journal of Bone and Joint Surgery
- Vol. 88 (2) , 403-410
Abstract
Background: Recent studies have shown that arthroscopic rotator cuff repairs can have higher rates of failure than do open repairs. Current methods of rotator cuff repair have been limited to single-row fixation of simple and horizontal stitches, which is very different from open repairs. The objective of this study was to compare the initial cyclic loading and load-to-failure properties of double-row fixation with those of three commonly used single-row techniques. Methods: Ten paired human supraspinatus tendons were split in half, yielding four tendons per cadaver. The bone mineral content at the greater tuberosity was assessed. Four stitch configurations (two-simple, massive cuff, arthroscopic Mason-Allen, and double-row fixation) were randomized and tested on each set of tendons. Specimens were cyclically loaded between 5 and 100 N at 0.25 Hz for fifty cycles and then loaded to failure under displacement control at 1 mm/sec. Conditioning elongation, peak-to-peak elongation, ultimate tensile load, and stiffness were measured with use of a three-dimensional tracking system and compared, and the failure type (suture or anchor pull-out) was recorded. Results: No significant differences were found among the stitches with respect to conditioning elongation. The mean peak-to-peak elongation (and standard error of the mean) was significantly lower for the massive cuff (1.1 ± 0.1 mm) and double-row stitches (1.1 ± 0.1 mm) than for the arthroscopic Mason-Allen stitch (1.5 ± 0.2 mm) (p < 0.05). The ultimate tensile load was significantly higher for double-row fixation (287 ± 24 N) than for all of the single-row fixations (p < 0.05). Additionally, the massive cuff stitch (250 ± 21 N) was found to have a significantly higher ultimate tensile load than the two-simple (191 ± 18 N) and arthroscopic Mason-Allen (212 ± 21 N) stitches (p < 0.05). No significant differences in stiffness were found among the stitches. Failure mechanisms were similar for all stitches. Rotator cuff repairs in the anterior half of the greater tuberosity had a significantly lower peak-to-peak elongation and higher ultimate tensile strength than did repairs on the posterior half. Conclusions: In this in vitro cadaver study, double-row fixation had a significantly higher ultimate tensile load than the three types of single-row fixation stitches. Of the single-row fixations, the massive cuff stitch had cyclic and load-to-failure characteristics similar to the double-row fixation. Anterior repairs of the supraspinatus tendon had significantly stronger biomechanical behavior than posterior repairs. Clinical Relevance: The results of this study support the concept that double-row fixation can improve the initial fixation strength of arthroscopic rotator cuff repairs.Keywords
This publication has 22 references indexed in Scilit:
- All‐arthroscopic versus mini‐open rotator cuff repair: A long‐term retrospective outcome comparisonArthroscopy, 2003
- MECHANICAL STRENGTH OF ARTHROSCOPIC ROTATOR CUFF REPAIR TECHNIQUESJournal of Bone and Joint Surgery, 2002
- Arthroscopically treated proximal humeral fracture malunionArthroscopy, 2002
- Arthroscopic repair of medium to large full-thickness rotator cuff tears: Outcome at 2- to 6-year follow-upJournal of Shoulder and Elbow Surgery, 2002
- Arthroscopic rotator cuff repairArthroscopy, 2001
- Experimental Rotator Cuff Repair. A Preliminary Study*Journal of Bone and Joint Surgery, 1999
- Arthroscopic Repair of Full-Thickness Tears of the Rotator Cuff*Journal of Bone and Joint Surgery, 1998
- Arthroscopic rotator cuff repair: analysis of technique and results at 2‐ and 3‐year follow‐upArthroscopy, 1998
- Comparison of Open and Arthroscopically Assisted Rotator Cuff RepairsThe American Journal of Sports Medicine, 1995
- Arthroscopically assisted rotator cuff repair: Correlation of functional results with integrity of the cuffArthroscopy, 1994