Generation of Nanoparticles from Friction between Railway Brake Disks and Pads
Authors:
- Hyeong-Gyu NamgungHNHyeong-Gyu Namgung
- Min-Soo KimMKMin-Soo Kim
- Duckshin ParkDPDuckshin Park
- 23 March 2016
- journal article
- research article
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 50 (7) , 3453-3461
Abstract
In this study, we measured the size distribution of particles ranging in size from 5.6 to 560 nm that were emitted between brake disks and pads under various braking conditions in order to observe and analyze changes to the resulting particle size distribution over braking time. A peak of 178-275 nm (200 nm Peak) was observed in all braking conditions. However, the generation of spherical particles of a 10 nm range was observed only when the disk speed and brake force were above certain levels and intensified only when speed and brake force further increased. The total number concentration of ultrafine particles (no larger than 0.1 m; PM0.1) generated was found to correlate with disk speed and brake force. Thus, the generation of nanoparticles resulting from disk speed and brake force was attributable primarily to increases in the contact surface temperature. The critical temperature for the generation of nanoparticles of a 10 nm range was found to be about 70℃, which is the average temperature between the surface and the inside of the disk. If the speed or brake force was higher, that is the temperature of the contact surface reached a certain level, evaporation and condensation took place. Vapor then left the friction surface, met with the air and quickly cooled down to form nanoparticles through nucleation. When the newly generated particles became highly concentrated, they grew through coagulation to form agglomerates. Or the vapor condensed directly onto the surface of existing particles of about 200 nm (formed by mechanical friction).Keywords
Funding Information
- Ministry of Land, Infrastructure and Transport (15RTRP-B082486-02)
This publication has 34 references indexed in Scilit:
- Emissions of particulate matters from railways – Emission factors and condition monitoringTransportation Research Part D: Transport and Environment, 2010
- PM10 emission factors for non-exhaust particles generated by road traffic in an urban street canyon and along a freeway in SwitzerlandAtmospheric Environment, 2010
- Real-World Emission Factors for Antimony and Other Brake Wear Related Trace Elements: Size-Segregated Values for Light and Heavy Duty VehiclesEnvironmental Science & Technology, 2009
- Diffuse release of environmental hazards by railwaysDesalination, 2008
- Particle size and composition distribution analysis of automotive brake abrasion dusts for the evaluation of antimony sources of airborne particulate matterAtmospheric Environment, 2007
- Metal Emissions from Brake Linings and Tires: Case Studies of Stockholm, Sweden 1995/1998 and 2005Environmental Science & Technology, 2007
- Airborne Brake Wear Debris: Size Distributions, Composition, and a Comparison of Dynamometer and Vehicle TestsEnvironmental Science & Technology, 2003
- Metal emissions from road traffic and the influence of resuspension—results from two tunnel studiesAtmospheric Environment, 2002
- Urban Metal Flows – A Case Study of Stockholm. Review and ConclusionsWater, Air, & Soil Pollution: Focus, 2001
- Brake Wear Particulate Matter EmissionsEnvironmental Science & Technology, 2000